Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
ALWAYS wear safety glasses and protective gear near battery. DO NOT TIP battery beyond a 45° angle in any direction. ALWAYS keep batteries out of reach of children. Hydraulics HYDRAULIC FLUID WILL CAUSE SEVERE BURNS. Fluid in the hydraulic system can penetrate the skin and cause death or serious injury. Cleaning Keep unit free of grass, leaves, or other debris. Clean up oil or fuel spills. Storage For unit storage or extended storage: • NEVER store with fuel in fuel tank, inside a building where any ignition sources are present • Allow engine to cool completely A Transport NEVER push or pull (tow) unit with another vehicle. Transmission damage will occur. Use extra care when loading or unloading unit onto trailer or truck. Block wheels and secure unit chassis to transport vehicle. NEVER secure from rods or linkages that could be damaged. DO NOT transport machine while engine is running. Attachments and Accessories Use only attachments or accessories designed for your unit. Check attachment components frequently. If worn or damaged, replace with manufacturer’s recommended parts. Avoid Tipover Use extra care with grass catchers and other attachments. These can change the stability of the unit. Use only approved hitch points. Clearances ALWAYS be aware of attachments when turning. ALWAYS allow adequate clearance between attachments, personnel, and other objects. DO NOT transport with attachment in the lowered (operating) position ALWAYS lower attachment when unit is parked or stored. Load Capacity Know the weight of loads. Limit loads to those you can safely control and the unit can safely handle. 8 Ariens® EZRider'" Rev. 1/97 SECTION 3 Operation Controls and Features See Figure 3 for Controls and Features locations. Travel-Steering Control Levers The Travel-Steering Control Levers are used to star, stop, steer and control the travel direction of the unit. Neutral Lock To start, lock unit in neutral by pushing both Travel-Steering Control Levers outward -to each side- from centered (neutral) position (Figure 4). Straight Forward Push the Travel-Steering Control Levers SLOWLY forward the same distance from the centered (neutral) position. The further you move the levers, the faster the unit will travel forward. (Travel-Steering Control Levers have quick response timing.) Straight Backwards (Reverse) Pull the Travel-Steering Control Levers back the same distance from the centered (neutral) position. The further you move the levers, the faster the unit will travel in reverse. Turns Move one Travel-Steering Control Lever forward and the other backward. Pushing the lever forward from the centered position moves the unit forward on that side; pulling the lever back from the centered position moves the unit backward on that side. 1. Left Lever further forward that Right Lever: turns unit to the right. 2. Right Lever further forward that Left Lever: turns unit to the left. Throttle Lever (Also Choke Lever on 1540 models) The Throttle Lever is used to change the speed of the engine. > . Moving the lever to the “FAST” position increases the engine speed. Moving the lever to the “SLOW” position decreases engine speed. Ignition Switch The Ignition Switch is operated with a removable key. The switch may be turned clockwise from the “OFF” position to the “START” position then the key will spring back to the “RUN" position. “OFF” Position: Ignition system is shut down. “RUN” Position: All controls are operable. “START” Position: Starter turns over the engine. To start the engine the key must be in the “START” position. To stop the engine, turn the key to the “OFF” position. N Choke Control 1648 Models: The engine is choked by pulling Choke control out to “CHOKE" position. 1540 Models: The engine is choked by moving the Throttle Lever to the “CHOKE” position. Parking Brake To engage the Parking Brake, lift up on knob and pull forward until it stops. To disengage Parking Brake, lift up on knob and push backward until it stops. If one or both of the rear wheels do not turn easily, check brake to assure it is disengaged. NOTE: Engine will shut off if control levers are taken out of neutral with brake engaged. Ariens» EZRider'“ Orig. 1/98 9 1. Operator’s Seat 2. Travel-Steering Control Levers 3. Battery Compartment 4. Choke Control (1648 Models) 5. Ignition Switch 6. PTO Switch 7. Throttle Lever (also Choke Control for 1540 Models) 8. Parking Brake Knob 9. Mower Deck Attachment Lift Lever 10. Foot Rest 11. Anti-Scalp Rollers 12. Mower Deck Attachment 13. Discharge Chute 14. Engine Shroud Cover Figure 3 10 Ariens» EZRider™ Orig. 1/98 Neutral Lock Position Power Take Off (PTO) Switch The Power Take Off Switch is used to engage and disengage the attachment. When the PTO Switch is pulled out, it is in the “ON” position and the attachment is engaged. When the PTO Switch is pushed in, it is in the “OFF” position and the attachment is disengaged. A...
Эта инструкция также подходит к моделям:Газонокосилки - 008-1540 (1.55 mb)
Газонокосилки - 010-1540 (1.55 mb)