Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
To reduce the risk of death by electric shock: 1. Always “unplug it” immediately after using. 2. Do not use while bathing. 3. Do not place or store appliance where it can fall or be pulled into a tub or sink. 4. Do not place in or drop into water or other liquid. 5. If an appliance falls into water, “unplug it” immediately. Do notreach into the water. WARNING—To reduce the risk of burns, electrocution, fire, or injury to persons: 1. An appliance should never be left unattended when plugged in. 2. Close supervision is necessary when this appliance is used by, on or near children or individuals with certain disabilities. 3. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Andis. 4. Never operate this appliance if it has a damaged cord or plug, ifit is not working properly, if it has been damaged, or dropped into water. Return the appliance to an Andis Service Center forexamination and repair. 5. Keep the cord away from heated surfaces. Do not wrap the cord around the appliance. 6. Never block the air openings of the appliance or place it on asoft surface such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, etc. 7. Never use while sleeping. 8. Never drop or insert any object into any openings. 9. Do not use outdoors, or operate where aerosol (spray) products are being used or where oxygen is being administered. 10. Do not use an extension cord with this appliance. 11. Do not direct hot air toward eyes or other heat sensitive areas. 12. Attachments may be hot during use. Allow them to cool beforehandling. 13. Do not place appliance on any surface while it is operating. 14. While using the appliance– keep your hair away from the air inlets. 15. Do not operate with a voltage converter. 16. Be sure dual-voltage selector is in correct voltage position before operating. Before plugging in, read the informationabout dual voltage contained in the instruction section of thismanual. 17. This appliance was set at the factory to operate at 125 volts. Refer to Operating Instructions section of this manual for conversion to 250 volt operation. This appliance is intended for household use. SAVE THESE INSTRUCTIONS OPERATING INSTRUCTIONS This appliance has a polarized plug (one blade is wider than the other). As a safety feature, the plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still doesn’t fit, contact a qualified electrician. Do not attempt to defeat this safety feature. If this unit shuts itself off, the thermal protectors that are built into this dryer may have operated. If the unit still does not run after being allowed to cool, return the unit for servicing. Heat Selections and Cool Shot This dryer is equipped with a cool shot button. To achieve the cool 125250 Cool Shot shot of air, just press the button located on the front top portion of the handle. The cool shot is ideal for locking in curl for longer lasting style. Just concentrate cool air on desired curl until set. LOW OFF Voltage Selection HI First, be sure switch is in the “Off” position before attempting to change voltage selection. To set to the required voltage, turn selector until slot is in line with dot above required voltage marking. The voltage selector switch should be placed in the 125 volt position. For use in several countries overseas, the voltage selector may need to be placed in the 250 volt position. Confirm the voltage available at each overseas location before using the appliance. When operating at 250 volts, the unit will only work with the switch in position “LO” . This setting will provide high heat and high blower speed. Do not try to operate with the switch in position “HI” when operating at 250 volts. For connection to a 250 volt supply, use an attachment plug adapter of the proper configuration for the power supply receptacle. To Remove Air Intake Grill This Andis dryer is equipped with a removable air intake grill. This grill may be removed for ease of cleaning excess hair and lint that can clog up a hair dryer. To remove the grill, simply depress the wing tabs on the side of the grill. Grill and foam filter are two separate pieces, be sure not to lose filter when cleaning. To clean grill that has been removed from the dryer, take a small brush and mild cleaning solution and lightly brush away excess lint and hair. Rinse and dry both pieces. Be sure that both pieces are completely dry before returning it to the dryer. Once they are completely dry, position the foam filter in place and snap grill back into place. USER-MAINTENANCE INSTRUCTIONS This appliance does not require special maintenance, cleaning or lubrication. Service only through authorized Andis repair stations. Untwist cord before use. After use, rewrap cord and store unit in a safe place. Do not wrap cord tightly around appliance. Do not hang the unit by the power cord. Cleaning • Th...