Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
.. .... Ingersoll Rand © 2006 Ingersoll-Rand Company Limited Security Technologies 829168-00 INSTALLATION Q Mark frame hole locations. A. Open hinge and place frame leaf flat against surface of frame leaving 1/8” gap between top of hinge and frame header. Hinge lip should be held tight against the frame face from top to bottom. B. Mark all hole locations on frame using center punch provided. C. Drill all holes using #13 (.185”) or 3/16” (.188”) drill for metal frame. For wood frame use 5/32” (.156”) drill. Optional wood screw pack required. D. DO NOT install hinge to frame at this time. Q Mount hinge to door. A. Place door leaf of hinge against hinge edge of door so that top of hinge is flush with top of door. Hinge aligment lip must lay flat against full length of door. B. With hinge held firmly in place, mark all hole locations on frame using center punch. C. Drill all holes as in step 1. D. Attach hinge leaf to door using fasteners provided and #3 phillips drive. See screw chart below. Note: Fasten top screw first, and bottom most screw second, making sure hinge is aligned correctly. Screw Chart Door & Frame Material Screw Type Metal frame & metal door #12-24 flat head screws Metal frame & wood door* #12-24 flat head screws (frame) #12 x 1-1/2” flat head wood screws (door) Wood frame* & wood door* #12 x 1-1/2” flat head wood screws *Optional wood screw pack required. Q Mount door to frame A. With door held securely, position door 90 degrees to opening and align mounting holes in frame leaf of hinge with marks on frame made in step 1. Note: An angle block, jack or shims will be helpful in positioning the door properly. B. With hinge and door held securely and accurately in place, install #12-24 flat head screw through top hole in frame leaf of hinge and into frame. Align other holes and install all other remaining screws. Frarne Q Check for proper operation and clearances. Close door and check for proper operation. B. Check push side of door for proper clearances. Clearance for single door is shown to the right and double door is shown below. C. Check with NFPA 80 manual for clearance requirements on FIRE-RATED openings. Page 2 of 2 829168-00(1)...
Эта инструкция также подходит к моделям:Двери и окна - 112HD Series (195.53 kb)