Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
b. Remove the bottom louvered or radiant panel/hood assembly (refer to Homeowner’s Care and Operation Manual). Figure 2 -Remove Top Panel Remove Trim Panels as shown. The trim panels will be either Louvered Panels or Radiant Panels. Louvered Panels Radiant Panels c. Remove Bustles -Some models have bustles (as shown in Figure 3) which must be removed. If applicable, remove the top and bottom bustle by lifting them up and out. Bustles Figure 3 - Remove Bustles Lift Bustles Up And Off Only Some Models Have Bustles 2. Align Glass Door (see Figure 4) -Ensure the glass door assembly on the fi replace is properly aligned as follows: Note: Units with Modesty Panels - Remove the modesty panel, if necessary, as follows: Lift the modesty panel by the tab on the panel’s right end, pull the right end of the panel away from cabinet and then pull the panel diagonally out of the corner post slots on the left side of the unit. Remove the modesty panel carefully, so that none of the wires become loose or disconnected. a. Open the latch(es) at the bottom of the glass door assembly as shown in Figure 4 (refer to Homeowners Manual). b. Adjust glass door so that it is evenly spaced and aligned to the fireplace chassis on both sides. See Figure 4. c. Fasten the latch(es). Ensure that the latch(es) are engaged with the door’s vee-fl ange and fully closed. See Figure 4. Figure 4 -GLASS DOOR ADJUSTMENT Top Flange on Glass Door Bottom Vee-fl ange Glass Door Glass Door Latch Glass Door Firebox Floor Some models will have a modesty panel in the control compartment (in front of the valve). The appearance will vary from the example shown below. Modesty Panel 3. Install Firebox Bottom Cover Panel -For Models EDV-35/40/45, see Figure 5a. For Model EDVST see Figure 5b. ScrewStep 1 - Remove 2 fire- box bottom screws. Step 2 - Install the Firebox Bottom Cover Panel (#5 in Figure 1) using the existing screws that were removed. The top two holes on the panel align to corresponding holes on fi replace. Figure 5a -Install Firebox Cover For EDV-35/40/45 Models NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. For EDVST Model Only Step 1 - Remove the two #8 screws from the bracket screw cover on both sides. Step 3 - Install the Firebox Bottom Cover Panel (#5 in Figure 1) using the existing #10 screws. The bottom two holes on the cover panel align to cor- responding two holes on fi rebox bottom. Figure 5b -Install Firebox Cover Step 2 - Remove the two #10 screws from the firebox bottom on both sides (save screws). #10 Screw #8 ScrewBracket Screw Cover 4. For EDV, EDVST & EBVST models, reinstall modesty panel, ensuring all wires are securely connected. 5. Install Doorframe (see Figure 6) - Remove the arched doorframe from packaging. Position the top of the doorframe above the top of the glass doorframe (centered and approximately 1” above the top of the glass doorframe). Slide down so that the hooks catch on the back of the doorframe slide between the sides of the glass door and the corner...
Эта инструкция также подходит к моделям:Двери и окна - TAPD35C (436.27 kb)
Двери и окна - TAPD35ESP (436.27 kb)
Двери и окна - TAPD35SP (436.27 kb)
Двери и окна - TAPD40SP (436.27 kb)