Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
These doors have been tested and listed by Omni-Test Laboratories Inc. PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE. GENERAL INFORMATION The door assembly consists of a right and left glass panel assembly with the door handles factory mounted. There are no additional parts that are required to install these doors. Fireplaces listed on the front page of this document, have been designed to accept these doors with minimum effort. TOOLS REQUIRED Medium Phillips Screwdriver • ..." Open-end wrench INSTALLATION PROCEDURE Step 1. Starting with the lower end of either the right or left hand door hold the door at a slight angle to the door frame outer edge with the top tilted toward the center. FIREPLACE KITS AND ACCESSORIES INSTALLATION INSTRUCTIONS FOR OUTDOOR BI-FOLD GLASS DOORS 43LBFOD-BS, 42ABFOD-BS & 36ABFOD-BS 750,141M BI-FOLD GLASS DOORS 06/2006 Step 2. Tilt the top of the door into place and carefully ensure that the upper pivot pin and roller pin is in the upper door guide track. Step 3. Continue to tilt the top of the door into place until the upper pivot pin engages the spring clip and the pivot pin locks into place within the hole of the spring clip (see Figure 3 ). Figure 1 Figure 2 Lower Pivot Pin Swing the lower corner of the door over the hole in the lower frame and engage the lower pivot pin into the hole on the lower frame of the firebox opening (Figures 1 and 2 ). Step 4. Repeat this procedure for the opposite door assembly. Pivot Point Lower Frame Pivot Pin Roller Pin Lock Spring Clip Upper Door Pivot Pin Guide Track Roller Pin Figure 3 ADJUSTMENT FOR DOOR ALIGNMENT The doors are properly adjusted when the top door trim is in a straight, level line and the gap between the doors is even at the top and bottom. If adjustments are required, grasp the door handle and loosen the lower door pivot pin using a ..." open end wrench*. Slide the door panel on the hinge pin until the gap between the upper door trim and upper frame is even. Retighten the lower door pivot pin*. Repeat this procedure for the opposite door if needed. *Note: Upper door pivot pins can also be loosened for adjustment purposes; however, it is easier to loosen lower pins. GENERAL OPERATING PRECAUTIONS AND INSTRUCTIONS CAUTION: THESE GLASS DOORS ARE LISTED ONLY FOR USE WITH THE FIREPLACE OR APPLIANCE MODELS SHOWN ON THE FRONT PAGE. USE ON ANY OTHER FIREPLACE OR APPLIANCE MAY CONSTITUTE A POTENTIAL FIRE HAZARD. • Avoid building extremely large fires as the tempered glass could become damaged. • Use fireplace tools carefully to avoid striking the glass. • Keep wire mesh screens closed during fireplace use. • The fireplace flue damper must remain open until fire is completely out. • Assure wood and embers are well within the confines of the grate area and well away from the glass doors. • Keep glass doors closed at night when retiring to minimize the loss of heated room air up the vent. IMPORTANT: THE FINISH OF THESE DOORS MAY BE PROTECTED WITH A SELF ADHERING PLASTIC COATIN...
Эта инструкция также подходит к моделям:Двери и окна - LSO-43-H (97.85 kb)
Двери и окна - MP-36OD (97.85 kb)
Двери и окна - MP-42OD (97.85 kb)