The oven will begin to heat up. Switching off the oven Turn the function selector to the off position. Changing the settings The type of heating and temperature or grill setting can be changed at any time using their respective selectors. Care and cleaning If cleaned and properly cared for, your oven will keep its bright appearance and operating performance for many years to come. Advice on how to care for and clean your oven is provided below. Notes ¦ Different colours may be seen in your front panel due to the various materials used in its manufacture, such as glass, plastic and metal. ¦ Dark patches in the door's glass panel may seem to be dirt but they are in fact reflections from the oven light. ¦ Enamel burns at very high temperatures. This may cause slight discolouration. This is normal and does not affect the oven's operation. The edges of thin baking trays may not be completely enamelled. They may therefore feel slightly rough, although their corrosive protection will be unaffected. Cleaning products Follow the indications provided in the table to avoid damaging the various oven surfaces by using unsuitable cleaning products. Do not use ¦ abrasive or acidic cleaning products ¦ strong products containing alcohol ¦ scourers or hard sponges ¦ high-pressure or steam cleaners Wash new dishcloths thoroughly before use. Zone Cleaning products Front panel Stainless steel Glass panel Hot water and a little soap: Clean with a dishcloth and dry with a soft cloth. Do not use a glass cleaning product or a glass scraper. Hot water and a little soap: Clean with a dishcloth and dry with a soft cloth. Immediately remove any water marks, grease, cornflower or egg white stains since corrosion could occur underneath these marks or stains. Special products for the care of stainless steel and which are suitable for hot surfaces may be obtained from Technical Assistance Service centres and specialist retail outlets. Use a very fine soft cloth to apply the cleaning product. Glass cleaning products: Clean using a soft cloth. Do not use a glass scraper. Glass panels on oven Glass cleaning products: door Clean using a soft cloth. Do not use a glass scraper. Oven interior Hot water with a little soap or water and vinegar: Clean with a dishcloth. If very dirty, use a stainless steel scourer or special oven cleaning products. These must only be used when the oven interior is cold. Glass cover for the oven Hot water and a little soap: light Clean with a dishcloth. The seal Hot water and a little soap: Do not remove! Clean with a dishcloth. Do not rub. Zone Cleaning products Wire shelves or rails Hot water and a little soap: Soak and clean using a dishcloth or brush. Sliding guides Hot water and a little soap: Clean with a dishcloth or a brush. Do not leave this to soak or wash in a dishwasher. Accessories Hot water and a little soap: Soak and clean using a dishcloth or brush. Light The oven light can be turned on manually to facilitate cleaning. Connecting the oven light Turn the function control knob to the N setting. The light will come on. The temperature control knob must be turned off. Turning the oven light off Turn the function control knob to the Uposition. Removing and refitting the wire shelves or left and right hand side rails The wire shelves or left and right hand side rails can be removed for cleaning. The oven must be cold. Release the guides or rails 1. Lift the front of the guide or rail and release it (figure A). 2. Then pull the guide or rail forwards completely and remove it (figure B). Unhooking and hanging the oven door The front panel can be unhooked to help remove the oven door and clean the glass panels. The oven door hinges are fitted with a locking lever. The door cannot be unhooked if the locking lever is closed ( figure A) . Once the locking lever has been opened to unhook the door (figure B) , the hinges will be locked in position. This prevents the door from suddenly closing. : Risk of injuries.! The hinges may close suddenly if they are not locked in position by the lever. Note that the locking levers are always closed, apart from when unhooking the door, when the levers must be open. Unhooking the door 1. Fully open the oven door. 2. Remove both locking levers located on the right and left hand sides ( figure A) . 3. Fully close the oven door as far as possible (figure B) . Grip the left and right hand sides of the door with both hands. Close the door slightly more and remove it. Clean the guides or rails with detergents and a sponge. The use of a brush is recommended for stubborn stains. Install the wire shelves or rails 1. First insert the shelf or the rail in the rear groove by pushing it back slightly ( figure A) 2. then insert it in the front groove (figure B). Wire shelves or rails can be adjusted on the left and right hand side. Their curvature should always be face down. Hanging the door Rehang the door by following the same steps but in reverse order. 1. When refitting the door, check...

Эта инструкция также подходит к моделям:
Духовые шкафы - 3HB511XM/01 (407.31 kb)