|
Фрагмент инструкции
Certain cleaning condition. agents such as gasoline, carbon tetrachloride, ammonia, etc. may damage plastic parts. Safety Rules for Drivers Hold tool by insulated gripping surfaces trigger lock is "OFF". Accidental start-ups when performing an operation where the could cause injury. cutting tools may contact hidden wiring Position the cord clear of rotating driver. or its own cord. Contact with a “live” wire Do not wrap the cord around your arm or will make exposed metal parts of the tool wrist. If you lose control and have the cord “live” and shock the operator. Do not drill, wrapped around your arm or wrist it may fasten or break into existing walls or other entrap you and cause injury. blind areas where electrical wiring may exist. If this situation is unavoidable, disconnect all Be aware of the location and setting of fuses or circuit breakers feeding this the switch "Lock-ON" button. If the switch worksite. is locked "ON" during the use, be ready for emergency situations to switch it "OFF", by Always wear safety goggles or eye first pulling the trigger then immediately protection when using this tool. releasing it without pressing the "Lock-ON" Secure the material being fastened. Never button. hold it in your hand or across legs. Be prepared for a strong reaction torque Unstable support can cause the drill bit to when "seating" or removing a screw. The bind causing loss of control and injury. driver motor housing will tend to twist in the Never leave the trigger locked "ON". opposite direction when "seating" or Before plugging the tool in, check that the removing a screw. -3 BM 3609929656 10/03 10/17/03 12:13 PM Page 4 Do not use dull or damaged bits and !WARNING Some dust created by power sanding, sawing, accessories. grinding, drilling, and other construction Check to see that keys and adjusting activities contains chemicals known to wrenches are removed from the driver cause cancer, birth defects or other before switching the tool "ON". Keys or reproductive harm. Some examples of wrenches can fly away at high velocity these chemicals are: striking you or a bystander. • Lead from lead-based paints, Do not run the tool while carrying it at your side. A spinning drill bit could become • Crystalline silica from bricks and cement entangled with clothing and injury may and other masonry products, and result. • Arsenic and chromium from chemically- treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. -4 BM 3609929656 10/03 10/17/03 12:13 PM Page 5 Symbols IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. Symbol Name Designation/Explanation V V...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - 1404VSR (294.71 kb)
Дрели и шуропопверты - 1404VSRL (294.71 kb)
Дрели и шуропопверты - 1405VSR (294.71 kb)
Дрели и шуропопверты - 1420VSR (294.71 kb)