Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Holding the work by hand operation. If damaged, have the tool or against your body is unstable and may serviced before using. Many accidents are lead to loss of control. caused by poorly maintained tools. Develop a periodic maintenance schedule for your Do not force tool. Use the correct tool for tool. your application. The correct tool will do the job better and safer at the rate for which Use only accessories that are it is designed.Do not use tool if switch recommended by the manufacturer for does not turn it .ON. or .OFF.. Any tool your model. Accessories that may be that cannot be controlled with the switch is suitable for one tool, may become dangerous and must be repaired. hazardous when used on another tool. Disconnect the plug from the power Service source before making any adjustments, Tool service must be performed only by changing accessories, or storing the tool. qualified repair personnel. Service or Such preventive safety measures reduce the maintenance performed by unqualified risk of starting the tool accidentally. personnel could result in a risk of injury. For Store idle tools out of reach of children example: internal wires may be misplaced or and other untrained persons. Tools are pinched, safety guard return springs may be dangerous in the hands of untrained users. improperly mounted. Maintain tools with care. Keep cutting When servicing a tool, use only identical tools sharp and clean. Properly replacement parts. Follow instructions in maintained tools, with sharp cutting edges the Maintenance section of this manual. are less likely to bind and are easier to Use of unauthorized parts or failure to follow control. Any alteration or modification is a Maintenance Instructions may create a risk misuse and may result in a dangerous of electric shock or injury. Certain cleaning condition. agents such as gasoline, carbon tetrachloride, ammonia, etc. may damage plastic parts. Safety Rules for Drivers Hold tool by insulated gripping surfaces trigger lock is "OFF". Accidental start-ups when performing an operation where the could cause injury. cutting tools may contact hidden wiring Position the cord clear of rotating driver. or its own cord. Contact with a “live” wire Do not wrap the cord around your arm or will make exposed metal parts of the tool wrist. If you lose control and have the cord “live” and shock the operator. Do not drill, wrapped around your arm or wrist it may fasten or break into existing walls or other entrap you and cause injury. blind areas where electrical wiring may exist. If this situation is unavoidable, disconnect all Be aware of the location and setting of fuses or circuit breakers feeding this the switch "Lock-ON" button. If the switch worksite. is locked "ON" during the use, be ready for emergency situations to switch it "OFF", by Always wear safety goggles or eye first pulling the trigger then immediately protection when using this tool. releasing it without pressing the "Lock-ON" Secure the material bei...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - 1404VSR (294.71 kb)
Дрели и шуропопверты - 1404VSRL (294.71 kb)
Дрели и шуропопверты - 1420VSR (294.71 kb)
Дрели и шуропопверты - 1420VSRL (294.71 kb)