Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
3 After you have set both the hours and minutes, press TIME SET to confirm the correct setting. ™ Clock time also starts to run automatically after 60 seconds after you adjust the time. Helpful Hint : Press ALARM SET during time setting will switch to alarm setting mode. INSTALLATION POWER SUPPLY AND DEMO MODE 1 Check if the mains voltage, shown set, corresponds to your local mains If it does not, consult your dealer or service centre. 2 Connect the mains plug into the wall socket. switched on and the display will show the PHILIPS demo mode. . PH..IL..IPS scrolls across the display continuously. • Press the TIME SET to exit the demo mode and enter time setting mode. Helpful Hint : If power breakdown backup batteries are inserted, the display PHILIPS demo mode. 3 To disconnect the set completely from the mains supply, withdraw the mains plug from the wall socket. POWER BREAKDOWN BACKUP When the mains power fail, the complete clock radio will be switched off. When the mains supply returns, the display will show the PHILIPS demo mode and the correct clock time has to be set again. To retain the clock time and the set alarm time in the event of an AC mains failure or disconnection, insert two 1.5V batteries, type R06, UM3 or AA size ( not supplied) into the battery compartment: this will act as a power backup to retain the clock and alarm times only. (Operation of the backlight illumination, alarm and radio are excluded). 1 Open the battery door to insert batteries as indicated by the + and – symbols inside the battery compartment. Close the battery door. 2 Connect the mains plug to the wall socket. • Replace the batteries once a year, or as often as necessary. • Old and new or different types of batteries should not be used in combination. Batteries contain chemical substances, so they should be disposed of properly. RADIO 1 Press SLEEP / RADIO ON once to switch on the radio. 2 Select your waveband using the BAND switch. 3 Use TUNING to find your radio station. 4 Adjust the sound using VOLUME. 5 Press ALARM RESET / RADIO OFF to switch off. To improve reception: FM: extend and position the pigtail aerial to obtain optimum reception. MW (or LW) : uses a built-in antenna inside the set. Direct the antenna by adjusting the position of your set. SETTING THE ALARM General If you wish to use the alarm, first set the alarm time. There is a choice of two alarm modes, buzzer or radio. The alarm display shows the alarm time all the time and the alarm indicator appears if the alarm is set. Setting the alarm time and mode 1 Press ALARM SET for more than 2 seconds to enter alarm time setting mode. ™ ALARM and the alarm time digits flash. 2 Press HR or MIN repeatedly or hold down on the button to adjust the hours and minutes respectively. Release HR or MIN when you reach the correct setting. 3 Press ALARM SET to confirm alarm time setting. Helpful – If you press TIME SET when setting time setting mode. – It is not possible to repeat alarm mode is active. To select the alarm mode you set the ALARM switch to RADIO or BUZZER ( m) or ( ) appears respectively. • If you have selected the radio mode, loud enough to wake you up! ™ The gentle wake buzzer alarm increases its SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish same alarm setting for the following day: • Press ALARM RESET / RADIO OFF. ™ You will hear a beep tone confirming 24 hour reset activation. The respective alarm indicator remains in display. CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off, or during the alarm call: • Set the ALARM switch to OFF. ™ The selected alarm indicator disappears from the display. MAINTENANCE • If you do not intend to use the set for a long time, withdraw the mains plug from the wall socket. and remove the batteries. • Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing. TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. Do not open the set as there is a risk of electric shock. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee. Problem – Possible Cause • Remedy No sound/power – Volume not adjusted • Adjust the volume No display backlight – AC mains plug not securely connected • Connect AC mains plug properly REPEAT ALARM This repeats 1 During the alarm press REPEAT ALARM / BRIGHTNESS CONTROL. ™ The selected alar...
Эта инструкция также подходит к моделям:Часы - AJ3011/00 (2.03 mb)