Оценок - 2, средний балл: 4
(
)
)
|
Фото и характеристики Pioneer DEH-112E |
Фрагмент инструкции
In this case, be sure to connect to both connectors. 13 Speaker leads White: Front lett © White/black: Front lett © Gray: Front right © Gray/black: Front right © Green: Rear lett © Green/black: Rear lett © Violet: Rear right © Violet/black: Rear right © En ( Connections 3 C 3 , 20 This diaglam is tor DEH-1120MP/DEH-1100MPB/DEH-1100MR 21 To Rear output I r J 23 Power amp (sold separately) L _ . 14 Wired remote input Hard-wired remote control adaptor can be connected (sold separately). 15 Yellow/black It you use an equipment with Mute tunction, wire this lead to the Audio Mute lead on that equipment. It not, keep the Audio Mute lead tree ot any connections. / _ 16 Blue/white Connect to system control terminal ot the power amp (max. 300 mA 12 V DC). 17 Blue/white (7*) Connect to auto-antenna relay control terminal (max. 300 mA 12 V DC). 8 Blue/white (6*) The pin position otthe ISO connectorwil differ depends on the type ot vehicle. Connect 6* and 7* when Pin 5 is an antenna control type. In anothertype ot vehicle, never connect 6* and 7*. 22 Connect with RCA cables (sold separately) 24 System remote control 27 Rear speaker 25 Left 1 1 26 Right 1 [\®J + e 27 Rear speaker , ^ 28 Perform these connections when using the optional amplitier. Fig. 1 Abb. 1 Afb. 1 Pmc. 1 En ( Connections ) ( j Important • When this unit is installed in a vehicle without ACC (accessory) position on the ignition switch, red cable must be wired to the terminal that can detect the operation of the ignition key. Otherwise, battery drain may result. ACC position No ACC position • Use of this unit in conditions other than the following could result in fire or malfunction. — Vehicles with a 12-volt battery and negative grounding. — Speakers with 50 W (output value) and 4 ohm to 8 ohm (impedance value). • To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. — Disconnect the negative terminal of the battery before installation. — Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. — Place all cables away from moving parts, such as gearshift and seat rails. — Place all cables away from hot places, such as near the heater outlet. — Do not pass the yellow cable through a hole into the engine compartment to connect to a battery. — Cover any disconnected cable connectors with insulating tape. — Do not shorten any cables. — Never cut the insulation of the power cable of this unit in orderto share the power with other devices. Current capacity of the cable is limited. — Use a fuse of the rating prescribed. — Never wire the speaker negative cable directly to ground. — Never band together multiple speaker's negative cables. • Control signal is output through blue/white cable when this unit is powered on. Connect it to an external power amp's system remote control orthe vehicle's auto-antenna relay contro...
Эта инструкция также подходит к моделям:Автомагнитолы - DEH-110E (482.32 kb)