Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
These may damage external surfaces or remove indicator characters. Lens fogging • In cold climates, there may be a period after you turn on your vehicle's heater when the lens that guides the laser beam used in your CD player fogs up. If this happens, you cannot play compact discs. Take out discs and the fogging will disappear. If it does not return to normal after several hours, contact your Kenwood dealer. Heat protection • In warm climates, when vehicles are left standing in direct sunlight with the windows closed, the temperature inside can rise above 60°C. The unit's protection circuits will then display the message "HOLD" and prevent the player from operating. Just open the windows or turn on the air conditioning. As soon as the "HOLD" message disappears, player will operate normally. Stains, scratches, or warping can cause skipping, malfunction, or low sound quality. Take the following precautions to avoid damage to the compact discs. • Avoid touching the recorded side (the side without the titles on) when you hold a compact disc. • The reflective film on a CD-R or a CD-RW is more fragile than that on an ordinary music CD, and may peel off if scratched. Fingerprints on a CD-R or CD-RW are also more likely to cause skipping when the disc is played. For these reasons, handle the disc very carefully. Detailed handling instructions will appear on the CD-R or CD-RW package: read this information carefully before using the disc. • Do not stick paper tape, etc. on either stick of the disc. • Do not store discs where they will be exposed to direct sunlight (such as on the seat and dashboard) or high heat. A CD-R or CD-RW is more susceptible than a music CD to damage from high temperatures and humidity, and in some cases, may become unusable if left in the car for long periods of time. • If you do not use your unit for an extended time, remove the discs from the unit and put them in their cases. Do not leave them lying around without cases, piled up, or leaning on a wall and so on. • If you attach an adapter to an 8 cm (3") compact disc and load it into this unit, the adapter may be detached from the disc, causing damage to the unit. Do not use 8 cm (3") compact discs. Connections 90 45 0 O - N D Changer control cable (5m) Changer control terminal Control unit (optional) • Do not connect the changer control cable • Be sure to press the reset button after • Do not install an antenna of radio equipment changer output cable, for this could ¦ Setting the O-N switch Set the O-N switch (lying to the right of the EJECT key) depending on the unit connected, follows: Consult the instruction capable. That concerning 2CAUTION "O" "N" CD text-capable Not CD text-capable None KCA-S210A None KCA-S210A KCA-S200 N N O O O ¦ Accessories A . 1 B . 4 C . 4 D . 1 E . 1 ¦ Removing the transportation screws Remove all 3 transportation screws for protecting the internal mechanism before you start to install the unit. After removing the transport screw, retain it carefully and attach it again before transporting the unit again. NOTE Transportation screws ¦ Angle adjustment switches • The angle adjustment switches on the both side of the unit are to be set according to the angle of installation of the CD auto changer. Set both of the two switches to the same position. If the switches are not set properly, sound skip or other malfunction may occur. • Set the angle adjustment switches with a coin or other flat object. • Change the switch step by step by detaching and reusing the object at the end of each step. 90 0 45 90 0 45 Right side Left side Angle adjustment switches It is not possible to install at an angle of 40°~50° if only A is used. 90 0 45 90 0 45 90 0 45 Installation angle Angle adjustment switch position 0°~5° 40°~50° 85°~90° ' Loading compact discs ' ' O - N ' ' ' Make sure the disc magazine is the right way up with the "disc" logo on the top.Pull the tray out by the projection. Projection "EJECT" 1 2 3 4 5 6 Tray Place the disc on the tray with the label facing upwards. Insert the tray into the disc magazine until it locks. Check that the discs and trays are inserted properly. The discs are numbered from the bottom from 1 to 6 or 10. • Take care to insert trays into the correct grooves in the disc magazine and to insert discs properly into the tray grooves. Otherwise malfunction may occur or the disc may be damaged. • Insert all trays even when some of them do not carry discs. Otherwire malfunction or operation failure may occur. • 8-cm discs cannot be used. If an 8-cm disc adapter is used, the disc cannot be ejected. 2CAUTION Open the CD changer door. Insert the magazine into the CD changer until it clicks. Close the CD changer door. Use the CD changer with its door closed to prevent the entry of dust into the changer. NOTE Open the CD changer door, and press the "EJECT" button. Be sure to open the door completely before pressing the EJECT button. If the door is not completely open, the magazine may hit the door and cau...
Эта инструкция также подходит к моделям:Автомагнитолы - KDC-C717 (249.33 kb)