Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
Each stereo method can also be used for mono or DVC applications. Figure 3.7 shows a Home Theater wiring scheme. A/V Receiver/Amplifier • Two separate 2 conductor speaker wires run from the A/V Receiver or amplifier to each stereo speaker. +-+- +-+- Figure 3.2 - Wiring: Amplifi er to Speakers-2 Conductor Direct • One 4-conductor speaker wire runs from the amplifier to a splice near one speaker. A 2-conductor wire runs from the splice to each speaker. A/V Receiver/Amplifier +-+- +-+- Splice 4 Conductor Wire 2 Conductor Wire Figure 3.3 - Wiring: Amplifi er to Speakers-4 Conductor to 2 Conductor © 2007 • All rights reserved. 5 Storm Series Ceiling Speakers Volume Control • One 4 conductor speaker wire runs from the amplifier to a stereo volume control, then one 2 conductor speaker wire runs to each stereo speaker. +-+- +-+- A/V Receiver/Amplifier 4 Conductor Wire 2 Conductor Wire Figure 3.4 - Wiring: Amplifi er to Speakers w/ Volume Control • Use any of the stereo wiring methods to connect to a DVC speaker. This example shows 2 separate 2 conductor speaker wires run from the amplifier to the DVC speaker. +-+- +-+- A/V Receiver/Amplifier Figure 3.5 - Wiring: Amplifi er to Speaker-DVC • Use any of the wiring methods to connect to a mono speaker. This example shows a 2 conductor speaker wire running directly from the amplifier to the mono speaker. + - + - A/V Receiver/Amplifier Figure 3.6 - Wiring: Amplifi er to Speaker-Mono 6 ©2007 • All rights reserved. Storm Series Ceiling Speakers • Five 2 conductor speaker wires run from the A/V Receiver to each surround sound speaker. A/V Receiver/Amplifier Figure 3.7 - Wiring: Amplifi er to Speakers-Home Theater Note 1: Low voltage wiring must be run in accordance with the National Electrical Code as well as any other applicable provisions of the local building codes in your area. In some cases (such as commercial installations), running the wire in conduit may be required. If you have any questions concerning the wiring of speakers in your home, contact your local building and inspection department. Note 2: It is recommended that you use quality CL-2 or CL-3 rated stranded speaker wire when installing ATON speakers. Solid-core “Romex” type wire is not acceptable! Use at least 16AWG speaker wire for runs up to 100 feet, and at least 14 AWG speaker wire for runs up to 200 feet. If you must cross high-voltage lines, always do so at a 90 degree angle to avoid audible hum through the speakers!. Note 3: When pre-wiring for ceiling speakers, it is essential to make direct wire runs from the head-end to each speaker. Do not run speaker wires in series or parallel, and do not “daisy-chain” speakers to common wiring. Storm Series Ceiling Speakers Pre-Wiring The audio/speaker cable runs should be routed from the head-end location to the speaker rough-in brackets (if used). At the speaker locations, securely fasten the speaker wire to the speaker rough-in bracket. If not using speaker rough-in brackets, staple speaker wire...
Эта инструкция также подходит к моделям:Акустика - A60C (915.01 kb)
Акустика - A60C (915.01 kb)
Акустика - A62ST (915.01 kb)
Акустика - A63C (915.01 kb)