Войти:
Оценок - 3, средний балл: 4 ( )

Инструкция по эксплуатации Bogen, модель 700286198

Производитель: Bogen
Размер: 610.26 kb
Название файла: 54-2101-01A.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Specifications subject to change without notice. 54-2101-01A 0308 Printed in Taiwan. Product Description You have purchased one of the finest pendant loudspeakers available today. Please familiarize yourself with this product by reading and reviewing the following descriptions and diagrams. These loudspeakers include a "spiderless" woofer that utilizes a high-gauss ferrofluid to guide the voice coil through the magnetic field.The benefits over conventional woofers with cloth spiders are several, including the ability to constantly adjust voice coil alignment, extend linear excursion, and the most efficient path for cooling the voice coil. In addition, the use of metal-alloy cone structures provides several benefits over the usual paper or plastic cone, such as elimination of cone flex or "break-up" in the operating ranges, additional thermal path for the voice coil to stay cool, and an extremely stable cone structure unaffected by the environment. The pendant loudspeaker is a full-range, wide dispersion system providing overhead sound coverage where ceiling structures are high but the sound needs to be closer to the audience/listener. Cable kits are provided for use as safety and main drop cables. Settings for 70V and 100V high-impedance systems, as well as a low-impedance (16-ohm) position, are provided. All models feature a removable snap-lock input connector, providing easy wire connection for input as well as loop-through to the next speaker. Product Diagrams Front Drawing 1.Tap Selection Switch 2. Coaxial Driver Assembly 3. Grille Retention Slot 4. Bass Tuning Vent (x2) 5. Perforated Steel Grille Rear Drawing 1. Snap-Lock Input Connector 2. Suspension Points (x3) 3. Safety Cable Suspension Point Package Contents (1) Pendant Speaker (1) Installation and Use Manual (1) Snap-Lock Input Connector (1) Quick-Snap Clip (2) Cable Kits (3) Suspension Cables with Forged Eye Bolts (3) Nuts (maybe installed onto eyebolts) Front Drawing (grille partially shown) Rear Drawing 1 Speaker Installation If the power level is known, then select it using the front-mounted selector switch prior to installing the speaker. See section Selecting Power Levels. Speaker Grille Removal Insert a pocket knife blade between the grille and the bezel about a 1/4" deep and then gently pry the grille upwards. Do this in multiple places around the circumference of the grille to free the grille. Speaker Grille Installation The speaker grilles fit tightly! Make sure the tap settings are correct prior to installing grille. Push the speaker grille in until it can go no further. Then, slap around the edge of the grille to seat the grille. The grille is properly seated when it is flush with the edge of the bezel. Suspension Cable Assembly 1. Screw nuts onto the eye bolts all the way to the flange. 2. Screw in eye bolts with captured cable sections in to the three suspension points. Do not overtighten. 3. Snap loops of free end of cable sections into quick-snap clip. 4. Connect quick-snap clip to drop cable. The supplied cable kit is suitable for use as the drop cable. Safety Cable The speaker includes a safety cable suspension point for extra protection. The included cable kit must be used as a safety cable. Refer to instructions with cable kits for proper use. 2...

Эта инструкция также подходит к моделям:
Акустика - 700286206 (610.26 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории