Войти:
Оценок - , средний балл: ( )

Инструкция по эксплуатации Black & Decker, модель ELECTROMATE 500

Производитель: Black & Decker
Размер: 249.66 kb
Название файла: 51c201ec-55a6-4d80-b324-290f7bfefe64.pdf

Язык инструкции:enes

Документ загружается, подождите пожалуйста
Документ загружается, подождите пожалуйста

Фрагмент инструкции


When utility power is restored, the unit automatically reverts to AC home power and Charging/Recharging Mode. Note: When connected to utility power, the unit automatically provides AC power from its internal battery in the event that utility voltage falls outside the 105–135 volt AC range. 5 AC ICON BPS500B ManualENSP 041008.qxp 4/10/2008 10:42 AM Page 6 SAMPLE RUN TIMES Appliance Watts* Run Time** Product Watts* Run Time** Laptop computer 30 12 h Table lamp 40 9 h Inkjet printer 20 16 h Desktop computer 70 5 h Cordless phone 5 74 h 17" LCD monitor 35 10 h Cell Phone 5 74 h 13" TV 50 7 h Internet modem 10 35 h Clock radio 6 62 h Combination of Appliances Run Time** Laptop, cordless phone, Internet modem/router up to 8 h 13" TV, cell phone charger, table lamp up to 4 h Desktop computer, 15" LCD monitor, inkjet printer, Internet modem, cordless phone, table lamp up to 2 h * Rated power may differ from appliance’s actual average power consumption. ** Run times are based on loads tested under regular operating conditions and are approximate. TROUBLESHOOTING General Problem Solution The unit will not power ON • Connect the unit’s power cord to the wall outlet securely • Make sure that the internal battery is charged (check the Battery Status Icon on the LCD Display). If charge is low, recharge the battery. If battery will not accept a charge after 24 hours, refer tothe “Service Information” section. Appliances connected to unit lose power A fault condition is present. Check the LCD Display for fault condition message and take the appropriate action (refer to the Fault Condition chart that follows). Appliances connected to unit malfunction or overheat Appliances connected to the unit do not accept modified sine wave form. Refer to “CAUTION: TO REDUCE THE RISK OF DAMAGING RECHARGEABLE APPLIANCES” on page 3. Inadequate run time Make sure that the internal battery is charged (check the BatteryStatus Icon on the LCD Display). If charge is low, recharge the battery. If battery will not accept a charge after 24 hours, refer to the “Service Information” section. Fault Conditions Following is a list of fault conditions, the corresponding LCD Display messages and recommended remedies. LCD Message Fault Condition Recommended Remedy OVERLOAD Shows when an overload condition exists (totalwattage draw exceeds 500 watts) or appliances connected to unit have a surge power that exceeds 500 watts. Reduce load to 500 watts (continuous). Manually reset unit by pressing ON/OFF Pushbutton OFF, then ON again. SHORT CIRCUIT PROTECTION Shows when an appliance that is plugged into the unit is short-circuited. Unplug the appliance from the unit and take appliance to a qualified technician for repair. Manually reset unit by pressing ON/OFF Pushbutton OFF, then ON again. LOW BAT LOW BATTERY WARNING. Shows when the unit’s battery charge level drops below 10.5 volts. An audible will sound. Disconnect load. Recharge battery (refer to “Charging/ Recharging the Unit”). CARE AND MAINTENANCE Storage 1. Ideal storage temperature range is 0-25°C (32-77°F). 2. Store and use the unit in a cool, dry place with adequate ventilation for all-around air circulation. 3. Avoid locations that are exposed to heating units, radiators, direct sunlight, or excessive humidity or dampness. Battery Replacement/Disposal This product has a sealed lead acid battery that should be kept fully charged. Charge before first use, immediately after each use, and once every two months if not used regularly. Failure to do this may reduce the battery life dramatically. 6 Should the battery need replacing, it is recommended that the unit be returned to manufacturer for battery replacement. Contact Customer Service, toll-free, at (800) 544-6986. This unit contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly. Recycling is required — contact your local authority for information. Failure to comply with local, state and federal regulations can result in fines or imprisonment. For more information on recycling this battery, call toll-free (800) 822-8837. WARNINGS • Do not dispose of product in fire as batteries inside this product may explode or leak. • Do not expose the unit containing a battery to fire or intense heat as it may explode. SERVICE INFORMATION All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page directory under "Tools—Electric" or call: 1-800-5446986 or visit CAUTION If the cord becomes damaged, return the entire unit to manufacturer immediately for service/repair. FULL ONE-YEAR HOME USE WARRANTY Black & Decker (U.S.) Inc. warrants this product for one year against any defects in material or workmanship. The defective prod...

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории