Производитель: Samsung
Размер: 490.76 kb
Название файла:
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Before installation & calling service
If you have further questions or your refrigerator has damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864).
1. Leveling & Door Alignment
2. Automatic Ice Maker does not work
6. Water dispenser dripping
9. Noise Clicks, Pops, Cracks, Snaps
• For details, refer to “Leveling the Refrig-
• Allow your refrigerator to operate
• If the water line is not inserted into the coupler
• You may hear these noises occasionally from
12
erator” in the User Manual.
and cool down for 24 hours
properly, air could penetrate into the water line
inside the refrigerator. This is normal. These
9
3
• Insert a flat-blade screwdriver into a slot on
(1 full day) before dispensing
causing water to drip from the water dispenser.
sounds occur when various items contract or
6
the control lever, turn it clockwise or counter-
large quantities of ice.
expand while temperatures inside the fridge are
clockwise to level the refrigerator.
• To fill the ice bucket to maximum capacity,
changing, especially during defrosting. You may
dispense a few cubes 8 and 16 hours after
also hear these noises when electronic devices,
installation.
including the ice maker, are operating.
• If ICE OFF or Ice Maker Off is lit, the ice
maker will not make ice.
10. Display (applicable models only)
Cabinet
Control Lever
• To activate the ice maker, press ICE OFF or
Tube
• Filter indicator : The filter Indicator turns red after
the Ice Maker Off button on the control panel
Dispenser Door
you use about 300 gallons of water (about 6
Flat-blade screw driver(-)
Tube
so it is no longer lit. (applicable models only)
months of usage). Reset the indicator (it will be
1. The Water Line must be fully inserted to the
Blue or off) after replacing the filter by holding the
When the refrigerator is empty, adjust
center of the transparent coupler (Type A)
filter reset button for 3 seconds.
CAUTION the Leveling Leg Control by turning it
or the Guide Lines (Type B) to prevent water
• Ice off : Press the “Ice Off” or “Ice Maker Off”
clockwise or counterclockwise with a
3. Water line is not connected
leakage from the dispenser.
flat head screwdriver until the Leveling
• Leaving the water line disconnected may cause
button to turn the ice making function off.
Legs contact to the floor.
the water valve to become noisy. The valve will
Type A
Type B
• Cooling Off (Show Room) mode : If the Display
This will allow better balance of the
generate a buzzing sound over time. If water
shows the “0F 0F” (or OFF) code, it means
Refrigerator when it is empty.
is not connected to the refrigerator, make sure
that the Cooling Off function is activated and the
Dispenser
that the ice making function is turned “OFF”
refrigerator is not cooling.
Door Alignment
and do not attempt to use the water dispenser.
To cancel the Cooling Off mode, press the multiple
Center of
The Guide Lines
buttons on the display specified in the user’s manual.
Type A
Transparent coupler
• Open the freezer drawer to gain access to
4. Small ice cubes, ice cubes with
11. Food stored in refrigerator is frozen
the adjustable hinge pin. Next, adjust the
bubbles, or slow water dispensing
refrigerator door using a philips screwdriver
7. Fridge or freezer Compartments are
• If food with too much moisture is stored near
(+).
• If the water filter is clogged, it may produce
warm
the cooling vents, it may get frozen. Be sure to
small ice cubes or bubbles inside the cube.
• Allow your refrigerator to operate and cool
keep moist food away from the cooling vents.
• Please replace the filter cartridge.
down for 24 hours (1 full day) to reach the
• After replacing the filter, please dispense at least
temperature you set.
12. Moving the Refrigerator
3 gallons (2-3 minutes) of water to remove any
• Also, when you put room temperature or warmer
• When moving the refrigerator, pull or push it
RAISE
trapped air from the water line.
food into your refrigerator, it may need an
straight forward or backward.
additional 24 hours to reach the set temperature.
Do not wiggle it from side to side.
Type B
8. Moisture forms on outside/inside of
• Adjust the door height difference by inserting a
5. Water is not cool enough
refrigerator
Snap Ring (1) as shown between the door and
• The first glass of water may not be cold enough
• Wipe off the condensation with a dry towel.
the hinge.
because the stored water in the water tank has
(This may occur during hot and humid weather.)
not cooled completely.
Insert one snap ring only of the
• If the condensation appears on the doors, turn
correct thickness.
Dispense several glasses of water until the
water is cool enough.
off the Energy Saving* function.
( * applicable models only)
(1)
• If you open the doors frequently or for too long,
it may cause moisture to form inside the fridge.
Keep the snap rings out of reach of
CAUTION children.
DA99-04022A-19
ENGLISH
DA99-04022A-19.indd 1
2016. 7. 1. �� 3:34
...Эта инструкция также подходит к моделям:
Холодильники - 4-Door Flex RF22K9381S Series (490.76 kb)
Холодильники - 4-Door Flex RF24J9960S Series (490.76 kb)
Холодильники - 4-Door Flex RF28K9070S Series (490.76 kb)
Холодильники - 4-Door Flex RF34H9950S Series (490.76 kb)