Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
It adheres to the current regulations for the prevention of accidents caused by refrigerating units (VBG 20). The cold circuit was tested for leaks. The appliance was built in compliance with the current safety regulations for electrical appliances. All electrical repairs should be carried out by qualified technicians. Improper repairs, carried out by persons lacking the necessary competence, could represent a major source of danger for the user of the appliance. EN Getting to know the appliance Before reading on, please unfold the illustrated pages at the back of this booklet. The operating instructions apply for several different models; it is possible, therefore, that the featured illustrations may not tally exactly with the particular characteristics of your own appliance. Overview Figure a 1 Ventilation grid 2 Ice-cube tray 3 Temperature selector/inner light 4 Racks 5 Meat container 7 Discharge gutter for thaw-water 8 Shelf 9 Vegetable bin 10 Kickstrip with ventilation outlet 12 Egg rack 13 Cheese compartment 14 Butter compartment 15 Container 17 Big shelf 18 Door seal 22 Freezer switch (Fig. d) A Deep-freezing compartment B Refrigerator Installing the appliance Where to install A dry, well ventilated room, is a suitable place for installing the appliance. Ensure that the appliance is not exposed to direct sunlight or placed near a source of heat such as: cookers, radiators, heaters, etc. If this is not to be avoided, make use of an adequate insulating plate to protect the appliance or, observe the following clearances between appliance and heat source: electrical cookers 3 cm. clearance oil- or coal-fired stoves 30 cm. clearance If the appliance is placed right next to another refrigerator or depp-freezer, observe a minimum clearance of 2 cm between the two of them. This will prevent condensed moisture formation. How to change the direction of door closure See attached assembly instructions. Lining-up the appliance The appliance must stand firm and on even flooring. If the floor is not even the appliance should be levelled using the adjustable feet at the front edge of the cabinet. (Figure s). Electrical connection Connect appliance to 220-230 V volts / 50 cycles a.c. Plug into a duly installed socket and protect socket with a 13 A fuse. Ventilation Ensure that the air caused to warm-up by the rear side of the appliance can ventilate unhindered. Otherwise, the refrigerating unit will be forced to increase its output and this will result in a higher rate of energy consumption. Observe, therefore, that the relief grid and ventilation outlets are never covered or blocked. EN Turning on and temperature selection Clean the inside of the appliance thoroughly, before using the first time (see cleaning). Turning on Turn temperature selector (Figure d) out of the position “O”. The refrigerating process begins. Should the door of the freezer compartment refuse to come open shortly after having closed it, please wait for two or three minutes for the s...
Эта инструкция также подходит к моделям:Холодильники - 3FS2510A/01 (569.32 kb)
Холодильники - 3FS3541SR/01 (569.32 kb)
Холодильники - 3FS3541SR/02 (569.32 kb)
Холодильники - 3FS3541SR/03 (569.32 kb)