Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
! Warning Redundant appliances: 1. Pull out the mains plug. 2. Cut off the power cord and discard with the mains plug. Refrigerators contain refrigerants and the insulation contains gases. Refrigerant and gases must be disposed of properly. Ensure that tubing of the refrigerant circuit is not damaged prior to proper disposal. en en Getting to know your appliance Please fold out the illustrated last page. These operating instructions refer to several models. The illustrations may differ. Fig.1 *not all models 1 On/Off button 2 Interior light 3 Light switch 4 Wooden shelf 5 Condensation outlet 6 Temperature selection button 7 Temperature setting display 8 Activated charcoal filter Installing the appliance Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e.g. acooker, radiator, etc. If installation next to a heat source is unavoidable, use asuitable insulating plate or observe the following minimum distances to a heat source: 3cm to electric or gas cookers. 30 cm to an oil or solidfuelcooker. Changing over the door hinges The door hinges on this appliance cannot be changed over. Aligning the appliance Fig.2 Place the appliance in the designated location and align. The front screw feet can be adjusted. en en Note ambient temperature and ventilation The climatic class can be found on the rating plate. It specifies the ambient temperatures at which the appliance may be operated. Climatic category Permitted ambient temperature N +16 °C to 32 °C ST +16 °C to 38 °C T +16 °C to 43 °C ! Attention The room temperature must not drop below +16°C. Otherwise the refrigerator compartment will become too cold and perishable items may be damaged. Ventilation Fig.3 The heated air on the side panels of the appliance must be able to escape freely. Otherwise, the refrigerating unit must work harder and the power consumption is increased. For this appliance there must be a 4cm gap between the wall and adjacent furniture. This distance is also required so that the door can be opened byat least 90°. Connecting theappliance After installing the appliance, wait at least 1hour until the appliance starts up. During transportation the oil in the compressor may have flowed into the refrigeration system. Before switching on the appliance for thefirst time, clean the interior of the appliance (seechapter Cleaning). The socket must be close to the appliance and must be freely accessible even after the appliance has been installed. Connect the appliance only to 220240V/50Hz alternating current via acorrectly installed earthed socket. Thesocket must be fused with a 10A to16 A fuse. If the appliance is to be operated in anonEur opean country, checkon therating plate whether the indicated voltage and current type correspond tothe values of your mains supply. Therating plate is situated in the bottom lefthand side of the appliance. Thepower cord maybe replaced by atechnician only. ! Warn...
Эта инструкция также подходит к моделям:Холодильники - KSW26V80/05 (2.45 mb)
Холодильники - KSW30V80/05 (2.45 mb)
Холодильники - KSW30V80GB/03 (2.45 mb)
Холодильники - KTW18V80/05 (2.45 mb)