Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
4. Clean all packages. 5. Seal strong smelling food in order to avoid odours from forming. 6. Switch the appliance on again. 7. Store food in the appliance. 8. Check whether the formation of odours is still occuring after 24 hours. Light ( LED) Your appliance features a maintenance- free LED light. These lights may be repaired by customer service or authorised technicians only. Tips for saving energy ¦ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source ( e.g. radiator, cooker) . If required, use an insulating plate. ¦ Select 560 mm cavity depth. A smaller cavity depth will result in a higher energy consumption. ¦ Allow warm food and drinks to cool down before placing in the appliance. ¦ Thaw frozen food in the refrigerator compartment and use the low temperature of the frozen food to cool refrigerated food. ¦ Open the appliance as briefly as possible. ¦ Regularly defrost the freezer compartment to remove the layer of frost. A layer of hoarfrost will impair refrigeration of the frozen food and increase power consumption. ¦ Ensure that the freezer compartment door is always closed properly. ¦ Occasionally clean the rear of the appliance to prevent an increased power consumption. ¦ The arrangement of the fittings does not affect the energy rating of the appliance. en Operating noises Quite normal noises Droning Motors are running ( e.g. refrigerating units, fan) . Bubbling, humming or gurgling noises Refrigerant is flowing through the tubing. Clicking Motor, switches or solenoid valves are switching on/off. Preventing noises The appliance is not level Please align the appliance with a spirit level. If required, place something underneath. Containers or storage areas wobble or stick Please check the removable parts and re- insert them correctly if required. Bottles or receptacles are touchingeach other Move the bottles or receptacles slightly away from each other. Eliminating minor faults yourself Before you call customer service: Please check whether you can eliminate the fault yourself based on the following information. Customer service will charge you for advice – even if the appliance is still under guarantee! Fault Possible cause Temperature differs greatly from the set value. Remedial action In some cases it is adequate to switch off the appliance for 5 minutes. If the temperature is too high wait a few hours and check whether the temperature has approached the set value. If the temperature is too low check the temperature again the next day. Displays do not illuminate. Power failhas been the mains has not bproperly. ure; the fuse switched off; plug een inserted Connect mains plug. Check whether the power is on, check the fuses. Temperature display indicates “ E..” . Electronics have detected a fault. Call customer service. en Fault Possible cause Remedial action Warning signal To switch off the warning signal, sounds, “ alarm” press the “ alarm” button 5. button lights up. Appliance is open. Close the appliance. Fig. 2/5 Ventilation openings Ensure that there is adequate The freezer have been covered. ventilation. compartment is too warm! Too m...
Эта инструкция также подходит к моделям:Холодильники - KI6773D40/01 (1.84 mb)
Холодильники - KI6773D40/02 (1.84 mb)
Холодильники - KI6773F30/01 (1.84 mb)
Холодильники - KI6863D30/01 (1.84 mb)