|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
¦ Do not use scouring or abrasive sponges. The metallic surfaces could corrode. ¦ Never clean shelves and containers in the dishwasher. The parts may become deformed! Proceed as follows: 1. Before cleaning: Switch the appliance off. 2. Pull out the mains plug or switch off the fuse. 3. Take out the frozen food and store in a cool location. 4. Clean the appliance with a soft cloth, lukewarm water and a little pH neutral washing- up liquid. The rinsing water must not run into the light. 5. Wipe the door seal with clear water only and then wipe dry thoroughly. 6. Rinsing water must not run through the drainage hole into the evaporation area. 7. After cleaning reconnect and switch the appliance back on. 8. Put the frozen food back in the freezer compartment. en Important care information for stainless steel appliances Use “ Chromol” cleaning agent for cleaning stainless steel surfaces. This cleaning agent is available on the market under the name “ Chromol” or from your customer service under ¦ ID-no. 310359 as a 500 ml spray bottle and ¦ ID-no. 166787 as a 50 ml spray bottle. To prevent damage to the surfaces, under no circumstances use abrasive sponges, metal brushes, sharp- edged implements or scouring agents. Chemically aggressive cleaning agents, such as defrosting sprays, oven sprays, solvents or stain removers must not be used either. The stainless steel surface should be cleaned in the direction of the grain. Tips for saving energy ¦ Install the appliance in a dry, well ventilated room! The appliance should not be installed in direct sunlight or near a heat source ( e.g. radiator, cooker) . If required, use an insulating plate. ¦ Do not block the ventilation openings in the appliance. ¦ Allow warm food and drinks to cool down before placing in the appliance! ¦ When thawing frozen products, place them in the refrigerator. Use the coldness of the frozen food to cool food. ¦ Open the appliance as briefly as possible. ¦ Ensure that the freezer compartment door is always closed properly. ¦ Occasionally clean the rear of the appliance with a vacuum cleaner or paint brush to prevent an increased power consumption. ¦ There must be a gap of 60 mm from the back wall so that the heated air can escape without obstruction. Operating noises Quite normal noises Droning Motors are running ( e.g. refrigerating units, fan) . Bubbling, humming or gurgling noises Refrigerant is flowing through the tubing. Clicking Motor, switches or solenoid valves are switching on/off. Preventing noises The appliance is not level Please align the appliance with a spirit level. Use the height- adjustable feet or place packing underneath them. The appliance is not free- standing Please move the appliance away from adjacent units or appliances. Containers or storage areas wobble or stick Please check the removable parts and re- insert them correctly if required. en Eliminating minor faults yourself Before you call customer service: Please check whether you can eliminate the fault yourself based on the following information. Customer service will charge you for advice – even if the appliance is still under guarantee! Fault Possible cause Temperature differs greatly from the set value. Remedial action In some cases it is adequate to switch off the appliance for 5 minutes. If the temperature is too high wait a few hours and check whether the temperature has approached the set value. If the temperature is too low check the temperature again the next day. Displays do not illuminate. Power failhas been the mains has not bproperly. ure; the fuse switched off; plug een inserted Connect mains plug. Check whether the power is on, check the fuses. Warning signal sounds. The alarm button is lit. Fault – the freezer compartmwarm! Fig. 2/4 ApplianceVentilation openings have been covered. Too much placed in compartment is too To switch off the warning signal, press the alarm button 4. is open. Close the appliance. Ensure that there is adequate ventilation. food was the freezer ent at once. Do not exceed max. freezing capacity. When the fault has been eliminated, the alarm button goes out shortly afterwards. en Fault Possible cause Remedial action Warning signal sounds. Alarm button flashes. Fig. 2/4 Fault – the freezer compartment is too warm! Frozen food is at risk! To switch off the warning signal, press the alarm button 4. Alarm button stops flashing. Note Frozen food which has started thawing or which has thawed can be refrozen if meat and fish were above + 3 ° C for not more than one day or other frozen food for not more than three days. If taste, odour and appearance have not changed, the food can be boiled or fried and then refrozen. No longer store the frozen produce for the max. storage period. Appliance is open. Close the appliance. Ventilation openings have been covered. Ensure that there is adequate ventilation. Too much food was placed in the freezer compartment at once. Do not exceed max. freezing capacity. When the fault has been eliminated,...
Эта инструкция также подходит к моделям:Холодильники - GS32NS52/01 (1.94 mb)
Холодильники - GS32NV91/01 (1.94 mb)