Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Separate all connection wires except for the earth line after. Hinge Upper hinge Connection \ wires Earth line 2) Remove the keeper by rotating it counter clockwise (®) and then lifting the upper hinge up (©). A CAUTION When removing the upper hinge, be careful that the door does not fall forwards. 3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out. _ 'Tower hinge NOTE Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube. 1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the earth line. 2) Remove keeper by rotating it clockwise (©) and then remove the upper hinge by lifting it up (d)). 3) Remove the refrigerator compartment door by lifting it up. Lower hinge Installation Pass the refrigerator Pass the refrigerator laterally through the access door as shown in the right figure. Door replacement Mount them in the reverse sequence of removal after they pass through the access door. Before installation A WARNING Feed water pipe installation ' Automatic ice maker operation needs water pressure of 147~834 kPa (1.5~8.5 kgf/cm2) (That is, an instant paper cup (180 cc) will be fully filled within 3 sec.). ' If water pressure does not reach the rating 147 kPa (1.5 kgf/cm2) or below, it is necessary to purchase a separate pressure pump for normal automatic icing and cool water feed. ' Keep the total length of the feed water pipe tube within 8 m and be careful for the tube not be bent. If the tube is 8 m or longer it may cause trouble in water feed owing to the drain water pressure. ' Install the feed water pipe tube at a place free from heat. ' Connect to potable water supply only. ' Refer to instructions with water filter kit for installation. Installation ^caution After leveling the door height Next When the freezer door is lower than the refrigerator door Insert the transparent sheet supplied with the product when the freezer door is lower than the refrigerator door. •Separate the door with the lower height,use the (+) type screwdriver to unscrew the screw at the bottom hinge as shown at Figure ®,insert the transparent sheet between the bottom hinge and the bottom bracket, and then fix it with the screw as shown at Figure © . • Insert more transparent sheets enough to align the height. (4 shttes are supplied in total.) Height difference Adjustable supports can be adjusted when the refrigerator is not stable. When the refrigerator door is lower than the freezer door Make adjustments when the refrigerator door is lower than the freezer door while using the refrigerator. 1. Use the wide side of the adjustment tool (D to rotate the tightening nut ® in clockwise direction to loosen it. 2. Use the narrow side of the adjustment tool (D to rotate the adjustment hinge pin (2) in either clockwise or counterclockwise direction to level the height of the refrigerator to that of the freezer. 3. After leveling the height of the door,rotate the tightening nut in counterclockwise direction to tighten it all the way. Height difference Adjustable supports can be adjusted when the refrigerator Is not stable. Do not adjust the height excessively. You can lose the hinge pin. (Height adjustable range: Maximum of 5mm) The refrigerator doors will close smoothly by heightening the front side by adjusting the height adjusting screw. If the doors do not close correctly, performance may be affected. 1. Wipe off all dust accumulated during shipping and clean your appliance thoroughly. 2. Install accessories such as the ice cube box, cover evaporating tray, etc., in their proper places. They are packed together to prevent possible damage during shipping. 3. Connect the power supply cord (or plug) to the outlet. Don't double up with other appliances on the same outlet. Operation Starting When your refrigerator is first installed, allow it to stabilize at normal operating temperatures for 2-3 hours prior to filling it with fresh or frozen foods. If operation is interrupted, wait 5 minutes before restarting. _____t \___ is!!? . V2!y ê _ to °c i—t w ti w D°c ji -A- $ $ HÛLD3SECS ( MONTH EXPRESS FRZ. CHILD LOCK 3SECS FREEZER DISPENSER REFRIGERATOR LIGHT/FILTER Q Q O O O Display Power Saving Mode NOTE • Your model may not include every option. Operation How to adjust the temperature in the freezer compartment How to adjust the temperature in the refrigerator compartment Express freezer Lock Display Power Saving Mode This function places the display into power saving mode until the next time the door is opened. Press the FREEZER and EXPRESS FRZ. buttons simultaneously and hold them for 5 seconds until the Ding sounds. All LED light will then turn ON, then OFF. When the power saving mode is activated, the display will remai...
Эта инструкция также подходит к моделям:Холодильники - GC-L207BLKV (19.06 mb)
Холодильники - GC-P207BAKV (19.06 mb)
Холодильники - GC-P207BLKV (19.06 mb)
Холодильники - GC-P207BTKV (19.06 mb)