Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
CAUTION 24 Energy-Saving Method 25 Energy-Saving Method • Install the fridge in a shady,cool and well-ventilated place. • Do not open and close the door frequently if not necessary. • Please do not keep the door open for a long time, close door in the shortest time. • Allow hot food to cool prior to storing. • Too much food are not advised to be put in. Enough space should be kept for cool air circulating freely. • Do not set the temperature of refrigerator lower than needed.Do not put the food near the temperature sensor. • Food need’t store is not advised to be put in. • Place the deep-frozen food for thawing intorefrigerator; they can be used for cooling the refrigerator. (Applicabe to some models only) • Clean up the back cover and anti-condensation pipe termly (once a year) to make sure heat exchange in gear. (Applicabe to some models only) • Do not block air vents with food. ( Applicabe to some models only) Suggestions on food storage Suggestions on food storage Storing Food Note Storing Food • Do not store food which goes bad easily at low temperature, such as banana, and melon. • Allow hot food to cool prior to storing. Placing hot food in the fridge-freezer could spoil other food, and lead to higher electric bills. • When storing the food, use a container with a lid. This prevents moisture from evaporating, and helps food to keep its taste and nutrients. • Do not block air vents with food. Smooth circulation of cold air keeps fridge-freezer temperature even. • Do not open the door frequently. Opening the door lets warm air enter the fridge-freezer, and cause temperature to rise. • To adjust the temperature control easily, do not store food near the temperature control dial. • Never keep too many foods in door rack, as this may stop the door from fully closing. • Do not store bottles in the freezer compartment - they may break when frozen. • Do not refreeze food that has been thawed. This causes loss of taste and nutrition. If you keep the fridge-freezer in a hot, and humid place, frequently open its door or put a lot of vegetables in it, dew may form in it, which has no effect on its performance. Remove the dew with dust cloth free from care. 26 Care and Maintenance General Information Power Failure If You Move Anti Condensation Pipe • 1~2 hour power failure does no harm to the foods stores. Try to avoid opening and closing the door too frequently. • Take out foods from the fridge-freezer and firmly fix the loose items with tape. • Turn the leveling screws until they stop before moving the fridge-freezer. Otherwise the screw may scratch the floor or the fridge-freezer cannot move. • The Anti-Condensation Anti-Condensation pipe is installed around the Pipe front side of fridge-freezer as well as on the partition between fridge compartment and freezer compartment to prevent dewing. • Especially after installation or when ambient temperature is high, the fridge-freezer may feel hot, which is quite normal. Lamp Replacement Use a DC12V 0.75W LED lamp broad. If LED lamp is damaged,it should be replaced by the service center in stead of on your own. 27•Lamp Care and Maintenance Cleaning Be sure to unplug the power. Before Cleaning Exterior Clean the outside of the fridge-freezer with a soft cloth soaked with hot water or liquid detergent. If you use a detergent, be sure to wipe it with a clean wet cloth. Interior As above. After Cleaning Check that the power cord is not damaged, power plug has not overheated, and that the power plug is tightly inserted into the outlet. Be sure to dry the appliance with a cloth after washing it with water. Do not use abrasive, petroleum, benzene, thinner, hydrochloride acid, boiling water, rough brush, etc, as they may damage parts of the fridge-freezer. 28 Care and Maintenance DRIP TRAY 1. Slowly pull the DRIP TRAY out. 2. Afte discharging drip water inside the DRIP TRAY, clean and fully rinse the DRIP TRAY. 3. Wipe moisture out around the DOOR part and the DRIP TRAY using a clean cloth. Wipe moisture etc out outside of Dispenser and on the DISPENSER PAD using a cloth. Exterior Dispenser WATER TANK 1. Lift the WATER TANK up by pressing the fixing LEVER on the bottom of WATER TANK and then remove it. 2. After removing the CAP TANK (BIG), clean and fully rinse the inside/outside part of the WATER TANK by using neutral cleansing agent. Clean and fully rinse the CAP TANK (Big & Small) by using neutral cleansing agent. CAP TANK (Big & Small) Especially for the groove part of the CAP TANK, it is convenient to cleanse it by using a small brush. Clean and fully rinse the VALVE ASSEMBLY by using a small brush. Rinse it while operating the bottom part of the valve assembly. Always fix the Sealing Rubber separated for cleansing at the existing position (may result in water leakage). VALVE ASSEMBLY 29 30Trouble Shooting Problem Fridge-Freezer does not operate Fridge or Freezer Compartment Temperature too warm Vibration or Rattling or Abnormal Noise Frost or Ice Crystals on frozen Foo...