Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
27 Trouble Shooting Problem Moisture collects inside Fridge has odor Door not closing properly Interior light does not work Possible Causes • Too frequent or too long door openings. • In humid weather, air carries moisture into fridge when doors are opened. • Foods with strong odors should be tightly covered or wrapped. • Check for spoiled food. • Interior needs cleaning. Refer to CLEANING section • Food package is keeping door open. Move packages that keep door from closing. • Fridge-freezer is not level. Adjust the leveling screws. • The floor on which the fridge-freezer is installed may be uneven or the fridge-freezer may be unstable. Slightly raise the front side with the leveling screw. • No power at outlet. • Light lamp needs replacing. Refer to the Lamp Replacement section Disposal of your old appliance 1. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. 2. Al l electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. 3. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health. 4. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product. 28 To Reverse the Doors Your fridge-freezer is designed with reversible doors,so that they may open from either the left or right hand side to suit your kitchen design. Precaution 1.Before reversing the door, first of all,you should take out food and accessories like shelves or trays which are not fixed in the fridge-freezer. 2.Use Torque Wrench or Spanner to fix or remove the bolt. 3.Do not lay the fridge-freezer down.This will cause problems. 4.Be careful not to drop the doors in disassembling or assenbling. How to Reverse the Door 1.To separate the door handle 1 of the left side, separate the door cap 2 and unscrew the screw 3 in counterclockwise direction.Separate the door handle 4of the freezer in the same order. (You do not need to follow the above procedure for the hidden handle.) 2.After unscrewing the screw 6 of the right hinge cover 5 on the top, separate the right hinge cover 5to separate the connecting cable 9.Separate the bolt 7fixating the upper right hinge 8 ,and carefully separate the refrigerator door 10 . 3.After separating the upper left cap 11 of the separated refrigerator door 10 , carefully take off the top cap 12 and pull the cable 13 to connect to the hole on the left side.Set the separated top cap 12 at the regular position and set the cap 11 on the cable hole on the right side.Loosen the screw 32 under the cold room door 10 , move it to the left of the stopper 31 , and then connect it. 4.Use a sharp gimlet or knife to disconnect the cap 15from the cover front 14 , loosen the screw 16 , and then move the cable 18 to the left to be mounted. Disconnect the cable 40 and the door switch 38 from the disconnected cover front 14 , swap the position of the disconnected cable 40 and door switch 38 with the cap 39 , mount them, fix them with the screw 16 , and then install the cap 15 . 143232 1011121331325679810 29 1615191418384039 30 Note Reversing the doors is not covered by the warranty. 1 3 2 38 2 1 38 38 3 2 3 2 30 21 25 26 21 20 29 27 32 31 31 33 30 28 21 24 5. Loosen the bolt of the Hinge Middle , remove the Hinge Middle , and lift up the freezer door to separate it. (When separating the refrigerator door, separate the bush 35 together.)Separate the hinge cover and set it on the separated part of middle hinge . After unscrewing the screw connected to the bottom cover connect the cover cap on the right side. Loosen the pin in counterclockwise direction and move to the hole on the left side to tighten in clockwise direction. Loosen the bolt connected to the lower hinge . Unscrew the screw fixating the door stopper at the bottom of the freezer door , and fixate it on the hole on the left side with the door stopper .And then, move the upper cap to the right and cover it. 27 35 23 28 29 21 22 20 25 6. Set the separate lower hinge on the bottom hole of the left side of the freezer, and tighten the bolt . After fixating the bottom cover at the regular position, align the freezer door 3 0 on the pin of lower hinge to attach it properly. Turn over the separated middle hinge and sheet hinge to assemble them. And set the bush and washer together to tighten the bolt . (When tightening the bolt, be careful not to cause an scratch on the cap decor on top of the freezer door). 8. Move the separated door handle to the right and fixate the screw on the right position to attach the door cap .Move the door cap on the right side to the left and attach it. Attach the freezer door handle in the same method as the refrigerator door handle . 10 21 37 36 9 19 7 6 7.After a...
Эта инструкция также подходит к моделям:Холодильники - GC-B399PLQK (5.54 mb)