Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
Do not place the equipment directly under the sunlight. The appliance must be positioned so that the plug is accessible after installation If the power cord is damaged it must be replaced by manufacturer, a certified service agent or qualified service personnel. This appliance contains a small amount of isobutane refrigerant (R600a), a natural gas with high environmental compatibility that is, however, also combustible. When transport ing and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged. Refrigerant squirting out of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any naked flames or potential sources of ignition and air the room in which the appliance is standing for several minutes. • In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating circuit occurs, the size of the room in which the appliance may be sited depends on the amount of refrigerant used. The room must be 1m3 in size for every 8 g of R600a refrigerant inside the appliance. The amount of refrigerant in your particular appliance is shown on the identification plate inside the appliance. • Never start up an appliance showing any signs of damage. If in doubt, consult your dealer. SAFETY • Any sharp edges may cause personal injury. Never put fingers or other objects into the dispenser hole and ice chute. It may cause personal injury or material damage Either R600a or R134a are the refrigerants used. Check the compressor label on the rear of the appliance and the rating label inside the fridge to see which refrigerant is used for your refrigerator. CAUTIONS The refrigerant used in the refrigerator/freezer and the gases in the insulation material require special disposal procedures. Ensure that none of the pipes on the back of the appliance are damaged prior to disposal. 3 SETTING UP THE REFRIGERATOR Once you have performed the following steps, your refrigerator should be fully operational. If not, check the power supply and electricity source. If you have any questions, contact your SAMSUNG service center. Place the refigerator in an appropriate location with reasonable clearance between the wall and the refigerator. (refer to installation instructions in this mannal) When the refrigerator is plugged in, the interior light should come on when you open the doors. Set the temperature control to the coldest temperature and wait for an hour. The freezer should get slightly chilled and the motor should run smoothly. Once the refrigerator temperature is sufficiently low, you can store food in the refrigerator. After starting the refrigerator, it takes a few hours to reach the appropriate temperature. MAJOR FEATURES Twin Cooling System • The refrigerator and the freezer have two evapora tors. Given this independent system, the freezer and the refrigerator are cooled individually as required and are, therefore, more efficient. Food odor from the refrigerator does n...
Эта инструкция также подходит к моделям:Холодильники - 21KCMS (2.08 mb)
Холодильники - 21KCSW (2.08 mb)
Холодильники - 21KLDW (2.08 mb)
Холодильники - 21KLLB (2.08 mb)