Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
(If not, the water supply line can be damaged.) • See “Separating the water supply line from the refrigerator” on the next page. Allow sufficient space to install the refrigerator on a flat surface. • If your refrigerator is not level, the internal cooling system may not work correctly. 5 Cm 1 Cm 10 Cm NOTE When you install the refrigerator, it is recommended that the clearance be maintained as much as specified above. If the space is not allowed, maintain at least 5cm clearance to the back wall. 20 REMOVING THE FRONT LEG COVER Removing the Front Leg Cover (Optional) Open the freezer and refrigerator doors, and then take off the front leg cover assembly by turning the three screws counter-clockwise. a FRONT LEG COVER SCREW Separating the water supply line from the refrigerator (Optional) 1) Remove the screw from clamp (a ). 2) Remove the water tube by pressing the coupler (.) and pulling the water tube (.) away. a Do not cut the water tube but separate it from the coupler. WARNING 21 INSTALLATION INSTRUCTIONS REMOVING THE REFRIGERATOR DOORS Removing the Freezer Door • Lift the door straight up. • Be careful not to pinch the water tubing and wire harness on the door. • Place doors on a protected surface.NOTE 1) With the door closed, remove the upper hinge cover (.) using a screwdriver, and then disconnect the wires (.). 2) Remove hinge screws (.) and ground screw (.) counter-clockwise, and take off the upper hinge (.) along the arrow (.). Take care when removing the door to ensure that it does not fall on you. 3) Remove the door from the lower hinge (.) by 4) Remove the lower hinge (.) using a screwdriver. carefully lifting the door (.). 22 REMOVING THE REFRIGERATOR DOORS Removing the Refrigerator Door 1) With the door closed, remove the upper hinge cover (.) using a screwdriver, and then discon-nect the wires (.). 2) Remove hinge screws (.) and ground screw (.) counter-clockwise, and take off the upper hinge (.) in the direction of the arrow (.). Take care when removing the door to ensure that it does not fall on you. 3) Remove the door from the lower hinge (.) by 4) Remove the lower hinge (.) from the bracket lifting the door (.). lower hinge (.) by lifting the lower hinge (.) in the direction of the arrow. NOTE • After disassembling the freezer / refrigerator door, move it to the appropriate location. you must reassemble it. INSTALLATION INSTRUCTIONS 23 REATTACHING THE REFRIGERATOR DOORS Reattaching the Freezer Door 1) Reattach the lower hinge (.) using screwdriver. 2) Reattach the freezer door by inserting the hose (.) in the lower side of the door into the hole in the lower hinge (.) and pulling the hose down. 3) Insert the upper hinge shaft (.) into the hole (.). After levelling the upper hinge hole (.) with the hole of the cabinet (.). Fasten bolts (.) and screw (.) in a clockwise direction. 4) Connect the wires. 5) Put the front part of the upper hinge cover ( ) on the front part of the upper hinge ( ) and reattach from the front part of t...
Эта инструкция также подходит к моделям:Холодильники - RS21DAMS (2.21 mb)
Холодильники - RS21DANS (2.21 mb)
Холодильники - RS21DASW (2.21 mb)
Холодильники - RS21DCMS (2.21 mb)