Оценок - 3, средний балл: 3.7 ( )

Производитель: Beko Размер: 449.71 kb Название файла: Язык инструкции:

• In the event of a possible malfunction, disconnect the device from the power mains first. • Prior to cleaning the device, always unplug the power supply or shut off the fuse. Do not pullfrom the cable - pull from the plug. • Repairs to the electrical equipment may only be made by qualified experts. If the connectioncable is damaged, the manufacturer or customer service must replace it in order to avoiddanger. 1 en en Transport instructions The device should be transported only in upright position. The packing as supplied must be intact during transportation. After a transport in the horizontal position, the device may only be taken into operation 4 hours after being stood up vertically again. The appliance must be protected against rain, moisture and other atmospheric influences. The manufacturer assumes no liability if safety instructions are disregarded. Disposal Make the device unusable immediately. Pull out the mains plug and cut the power cable. Remove or destroy snap or latch locks before disposing of the device. In this manner you prevent children from locking themselves in and endangering their lives. Device setup • Do not operate your appliance in a room where the temperature is likely to fall below 10 °C at night and/or especially in winter. At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food. • The climate class rate of your appliance is given in Technical Features leaflet and written on the rating label inside the appliance. It specifies the appropriate operating ambient temperatures as explained below. Climatic class Ambient temperatures SN.......................+10 °C to 32 °C N .........................+16 °C to 32 °C ST .......................+18 °C to 38 °C T..........................+18 °C to 43 °C SN-ST.................+10 °C to 38 °C SN-T ...................+10 °C to 43 °C Location Only place the device in dry rooms which can be aired. Avoid direct sunlight or direct heat sources such as a stove or a heater. If this cannot be avoided, the following minimum distances should be maintained: Electric stoves: 3,00 cm Heater: 3,00 cm Cooling devices: 2,50 cm • Ensure sufficient air circulation for your device. • Make sure that sufficient room is provided around the appliance to ensure free air circulation. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance (Fig. 3). • The device should be located on a smooth surface. The two front feet can be adjusted as required. To ensure that your appliance is standing upright adjust the two front feet by turning clockwise or counter-clockwise, until the product is in firm contact with the floor. Correct adjustment of feet avoids excessive vibration and noise. Electrical connections Warning This device must be grounded. • Check whether the power type and voltage in the device location corresponds to the one stated on the rating label inside the device. • The electrical safety of the device is only assured when the grounding system in the house is installed in accordance with regulations. • When putting the device in, do not stand it on the power cable, otherwise the cable will be damaged. • Ensure that the plug remains readily accessible. Do not use multiple adapter bar or extension cable. 2 en en Get to know your device Warning Below information about accessories are supplied just for reference. Below accessories may not be exactly same as the accessories of your appliance. Fig. 1 A) Freezer compartment B) Fridge compartment 1. Ice cube tray 2. Freezer shelf 3. Interior light 4. Thermostat knob 5. Fridge compartment shelves 6. Bottle and can rack 7. Defrost water collection channel - Drain tube 8. Crisper humidity controls 9. Crisper cover 10. Salad crisper 11. Adjustable front feet 12. Dairy compartment 13. Door shelf 14. Egg tray 15. Sliding storage boxes 16. Bottle shelf How to use the accessories Crisper separators (Fig. 7-a) The separators inside the crisper are designed to protect fruits and vegetables against bruising. Crisper humidity controls (Fig. 7-b) This has been designed to keep your vegetables fresh, without losing moisture. For this purpose, cold air circulates around the crisper. The amount of cold air passing out of the crisper can be regulated with the controls found on the front of its cover. You may set the humidity-control knob to the position appropriate to adjust the degree of moisture and coldness of the foodstuffs inside. If you want these to cool further, set the control to “Open”, if you want them to cool less but retain their moisture for a long period, set it to “Closed”. Positions in between allow you to regulate cooling and moisture-retention as you desire. Sliding storage boxes (Fig. 7-c) This accessory is designed to use the door shelves’ volume more efficiently. Moving those boxes right or left helps to easily settle high bottles to the shelf below. Bottle and can rack (Fig. 7-d) This acces...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: