Оценок - 2, средний балл: 5 ( )

Производитель: Carrier Размер: 216.63 kb Название файла: 227499en.pdf Язык инструкции:

7. Switch the appliance back on. Symptom Possible Cause Remedy Appliance is not switched on Switch on the appliance. Mains plug is not plugged in Insert mains plug. or is loose. Appliance does not work. Check fuse, replace if neces- Fuse has blown or is defective. sary. Mains malfunctions are to be Socket is defective. corrected by an electrician. Turn the temperature control Appliance cools too much. Temperature is set too cold. knob to a warmer setting. Temperature is not properly Please look in the "Initial Start adjusted. Up" section. Door was open for an exten- Open the door only as long as ded period. necessary. The food is too warm. A large quantity of warm food Turn the temperature control was placed in the appliance knob to a colder setting. within the last 24 hours. The appliance is near a heat Please look in the "Installation source. location" section. Please look in the "Changing Interior lighting does not work. Light bulb is defective. the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than Heavy build up of frost, possi- Door seal is not air tight (pos approx. 50 °C). At the same bly also on the door seal. sibly after reversing the door). time shape the warmed door seal by hand until it sits correctly. The compressor does not start This is normal, no error has The compressor starts after a immediately after changing occurred. period of time. the temperature setting. Water on the floor or on sto- Water drain hole is blocked. See the "Cleaning and Care" rage shelves. section. If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre. In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls. Defrosting Refrigerator Frost is automatically removed from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, located over the motor compressor, where it evaporates. Freezer The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. Remove the frozen food from the freezer, wrap it in several layers of newspaper and put it in a very cool place. 2. Switch off the appliance and pull out the plug, or turn the temperature control knob to “0” . 3. Leave the freezer compartment door open. 4. Insert the plastic scraper into the recess provided under the defrost water channel and place a collecting basin under it. 5. Once defrosting is completed keep the scraper handy for future use; 6. Turn the thermostat knob to the required setting or replace the plug in the power socket. Warning! Never use metal tools to scrape off the frost Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. Switching Off the Appliance To switch off the appliance, turn the temperature regulator to position "0" or disconnect from the electricity supply. If the appliance is not going to be used for an extended period: 1. Remove all refrigerated and deep-frozen packages as well as ice trays. 2. Remove the mains plug or switch off. 3. Defrost freezer compartment and clean thoroughly (see section: “Cleaning and Care”). 4. Leave the door open to avoid the build up of odours. Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. Warning! Before carrying out any cleaning or maintenance, disconnect the appliance from the electricity supply. • Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, which could cause an electric shock! Hot vapours can lead to the damage of plastic parts. • The appliance must be dry before it is placed back into service. Warning! • Ethereal oils and organic solvents can attack plastic parts, e.g. – lemon juice or the juice from orange peel, – butyric acid; – cleansers which contain acetic acid. Do not allow such substances to come into contact with appliance parts. • Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a l...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: