Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
To decrease the temperature (colder), turn clockwise. To increase the temperature (warmer), turn counter-clockwise - see diagram LOADING PRODUCT Shelves have been factory-installed for your convenience. Before loading shelves, please be sure that all shelf clips are completely fastened in their correct locations. It is important that all shelves rest completely level before stocking your cabinet with product. In order to maintain correct air flow inside the unit, please be sure to leave two to four (2 to 4) inches of space between the back wall and stored product. Blocking the evaporator fans will result in a warmer cabinet temperature, and ultimately compressor failure. DEFROST SYSTEMS Refrigerator coils are kept below the freezing point (32 F). During compressor down-time, the evaporator fan continues to circulate air through the evaporator coil. This air circulation raises the coil temperature above the freezing point, melting any accumulated frost. Run-off water is drained into the evaporator pan and evaporated. **Freezer coils are defrosted electrically.** Automatic defrost timers are built-in to the refrigeration system and may not be adjusted. The defrost timers automatically initiate at pre-set intervals and for a pre-determined duration. **PLEASE NOTE: Excessive door openings should be avoided in order to maintain cabinet temperature and to eliminate the possibility of coil freeze-up.** LOADING FOOD PANS Pizza prep units and sandwich prep units are designed to function with all pans in place, even if some pans are to be left empty. For maximum food freshness, fill the pans only with an amount that can be used in a specific usage period. During non-use, please close the insulated lid cover. -4- CAUTION Setting the temperature control to the coldest setting may cause the evaporator coil to freeze and ice up. This will eventually result in a warmer cabinet TEMPERATURE temperature. READING OFF 1 7 6 5 3 4 2 Temperatures range from 7 (coldest) to 1 (warmest). SAFETY / WARNING Please pay close attention the the safety notices in this section. Disregarding these notices may lead to serious injury and/or damage to the unit. KEY 1) To minimize shock and fire hazards, be sure not to overload outlet. Please designate one outlet for your unit. 2) Do not use extension cords. 3) Do not put your hands under the unit when the unit is required to be moved. 4) When the unit is not in use for a long period of time, please unplug the unit from the outlet. 5) After unplugging the unit, wait at least 10 minutes before re-plugging it. Failure to do so could cause damage to the compressor. 1) To minimize shock and fire hazards, please do not plug or unplug the cord with wet hands. 2) During maintenance and cleaning, please unplug the unit. 1) To minimize shock and fire hazards, make sure that the unit is properly grounded. 1) Do not attempt to remove or repair any component unless instructed by factory. 2) Make sure that the unit is not resting on or against the electrical cord and plug. 3) To minimize personal injury, do not hang on t...
Эта инструкция также подходит к моделям:Холодильники - U2BFF-12S (1.17 mb)
Холодильники - U1BRR-06S (1.17 mb)
Холодильники - U2BRR-12S (1.17 mb)