Оценок - 3, средний балл: 5
(
)
)
|
Фрагмент инструкции
If unit is damaged or parts are missing, notify your Absocold dealer at once. INSTALLATION REQUIREMENTS Remove all packing material and tape. Install on a level floor or well-supported counter. Avoid any direct sunlight, heat source, or moisture. This refrigerator is designed to be freestanding — that is, the appliance is to be installed at least 1.” from the wall and the cabinet bottom is at least .” to 1” above the floor or carpet, in order to let the air circulate freely around the refrigerator. If this appliance is recessed, built-inor otherwise enclosed to restrict airflow, then all warranties stated herein are null and void. ICE STORAGE COMPARTMENT This compartment is designed for production of ice cubes and short-term storage. The temperature in the ice storage compartment doesn’t get cold enough to store frozen foods safely. ELECTRICAL REQUIREMENTS 120 volts, 60 Hz. ELECTRICAL GROUNDING (for 120-volt models only) Must be grounded. Uses 110-120 volts, 60 Hz. (60 cycles A.C.) Do not use extension cord. Use three-prong plug, with three-prong grounded wall outlet. Unless the above grounding method is followed, you are not protected against severe or lethal shock, in the event of a short circuit of an electrical component or wiring of refrigerator. CAUTION Should you unplug refrigerator, allow at least three minutes before restarting in order to allow the start relay to function properly. USE AND CARE INFORMATION • TIPS ON EVERYDAY USE AND CARE TO CONTROL TEMPERATURE: Start by setting control on No. 3. Wait 24 hours for refrigerator to cool. Higher number is colder. Fresh food section should be as cold as possible without freezing vegetables or milk. Adjust as necessary. DEFROST: For the most efficient operation of your refrigerator, defrost it whenever a .”-thick layer of ice/frost forms (except for frost-free models). When defrosting, Turn off control. Remove all food from the refrigerator. Do not use heater devices to speed defrosting. Do not scrape or use sharp objects in the ice storage compartment. Let frost melt. Pan of warm water in ice storage compartments speeds defrosting. Empty defrost tray. Reset cold control. Replace food. FOR ALL CLEANING: Mix 2 tablespoons baking soda or mild soap with 1 quart warm water. No strong cleaners, scouring powder or pads should be used. Do not put the defrost tray in the dishwasher. Vacuum the tubing on outside back when dusty. • THINGS TO REMEMBER 1. Allow 24 hours for your refrigerator to reach a new temperature setting. 2. The motor will start and stop often. It must do so in order to maintain the temperature you select. 3. Keep your refrigerator reasonably level. 4. Unplug refrigerator before doing anything with its electrical system (even changing a light bulb). • BEFORE CALLING FOR SERVICE Check plug and outlet. Test outlet with lamp or other device. Be sure control is on. Read all Use & Care Information. Your questions may be answered. If not, find your model number (on upper back of refrigera...
Эта инструкция также подходит к моделям:Холодильники - ARD251M (87.29 kb)
Холодильники - ARD251M (87.29 kb)