Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Хлебопечки - SD2500WXC (5.92 mb)
Хлебопечки - SD2500WXC (6.06 mb)
Фрагмент инструкции
Troubleshooting
Before calling for service, please check through this section.
Problem
Cause Action
Problem
Cause Action
The dough menu was selected.
Extra ingredients are not mixed
Some of the bread mix dough is harder to mixed extra ingredients in or to flick out some of them.
English
The dough menu does not include a baking process.
properly in brioche.
Decreased the extra ingredients into half.
There has been a power failure, or the machine has been stopped during breadmaking.
The machine switches off if it is stopped for more than 10 minutes. You can try baking the
There is excess oil on the
dough in your oven if it has risen and proved.
Did you add butter within 5 min of the beep?
bottom of brioche.
There is not enough water and the motor protection device has activated.
Do not put butter when display show remaining time until ready. (P.17)
The crust is oily.
This only happens when the unit is overloaded and excessive force is applied to the motor.
Butter flavor might be weak, but it can bake.
My bread has big holes.
My bread has not been baked.
Visit place of purchase for a service consultation. Next time, check the recipe and measure
out the correct amount using the measuring cup provided.
You have forgotten to attach the kneading blade.
Try following things.
Make sure you attach the kneading blade first (P. 14).
It might be baked better if yeast is decreased a little when using menu 11 or 23 (SD-2500: 10
The kneading mounting shaft in the bread pan is stiff and does not rotate.
or 21). (If adding yeast separately.)
My brioche did not turn out well
If the kneading mounting shaft does not rotate when the kneading blade is attached, you will need
Follow the recipe on the bread mix, but the bread mix should be between 350-500 g.
when using bread mix.
to replace the kneading mounting shaft unit. (Consult the place of purchase or a Panasonic service
First place the measured yeast (If adding yeast separately) in the bread pan, dry mixture,
centre.)
butter, then liquid. When adding the extra ingredients, add them later. (P.17 or 19)
The completion is different according to recipe on the bread mix.
A small amount of dough will escape through the ventilation holes (so that it does not stop
the rotating parts from rotating). This is not a fault, but check occasionally that the kneading
If the bread cannot be easily removed from the bread pan, leave the bread pan for
mounting shaft rotate properly.
5–10 minutes to cool, making sure that it is not left unattended where somebody or something
If the kneading mounting shaft does not rotate when the kneading blade is attached, you
The bread does not come out.
may get burnt.
will need to replace the kneading mounting shaft unit. (Consult the place of purchase or a
After that, shake the bread pan several times using oven gloves.
Dough leaks out of the bottom of
Panasonic service centre.)
(Hold the handle down so that it does not get in the way of bread.)
the bread pan.
(Bottom of bread pan)
Kneading
The amount of the fruit was a too little, or the amount of sugar is too much.
mounting shaft
When cooking jam, it has
Place the bread pan in the sink and half fill the bread pan with warm water. Leave the
scorched or the kneading blade
Kneading
bread pan to soak until the cooked on mixture or kneading blade loosens. After scorching is
mounting shaft unit
fixes and it doesn’t come off.
relieved, wash it with a soft sponge etc. Please be aware of the hot water.
Ventilation holes (4 in total)
Kneading mounting shaft
Part no. ADA29E165
Too much fruit or sugar has been used.
The jam has boiled over.
You have left the bread in the bread pan for too long after baking.
Only use the amounts of fruit and sugar specified in the recipes on P. 29.
The sides of my bread have
Remove the bread promptly after baking.
collapsed and the bottom is
There has been a power failure, or the machine has been stopped during breadmaking.
The fruit was under or over ripe.
damp.
The machine switches off if it is stopped for more than 10 minutes. You may try baking the
Sugar was decreased too much.
dough in your oven.
Jam is too runny and not firmly
Cooking time was insufficient.
set.
Fruit with a low pectin content was used.
The kneading blade rattles.
This is because the kneading blade fits loosely on the kneading mounting shaft. (This is not a fault)
Use the runny jam as a sauce for desserts.
Leave the jam to cool completely. The jam will continue to set as it cools.
I can smell burning while the
Ingredients may have been spilt on the heating element.
bread is baking.
Sometimes a little flour, raisins or other ingredients may be flicked out of the bread pan during
Can frozen fruits be used?
It is possible to use them.
Smoke is coming out of the
mixing. Simply wipe the heating element gently after baking once the Bread Maker has cooled down.
steam vent.
Remove the bread pan from the Bread Maker to place ingredients.
What kinds of sugar can we use
White caster and granulated can be used.
on jam?
Do not use brown sugar, diet sugar, and low calorie sugar or artificial sweetener.
The dough is a little stiff.
The kneading blade stays in the
Allow the bread to cool completely before removing the kneading blade carefully.
When making jam, can we use
bread when I remove it from the
Some types of flour absorb more water than others, so try adding an extra 10-20 mL of water next time.
Do not use them. The quality is not satisfactory.
fruits are pickled in alcohol?
bread pan.
Crust has built up underneath the kneading blade.
Wash the kneading blade and its spindle after each use.
The fruit has collapsed when
The cooking time was too long. The fruit may have been over ripe.
The crust creases and goes soft
The steam remaining in the bread after baking can pass into the crust and soften it slightly.
making fruit in syrup.
on cooling.
To reduce the amount of steam, try using 10-20 mL less water or half the amount of sugar.
There has been a power failure for approx. 10 minutes (the plug has been accidentally pulled
To make your bread crispier, you could use the menu 08 (SD-2500: 07) or the ‘Dark’ crust colour
out, or the breaker has been activated), or there is another problem with the power supply.
How can I keep my crust crispy?
option, or even bake it in the oven at 200°C/gas mark 6 for an extra 5-10 minutes.
appears on the display.
The operation will not be affected if the problem with the power supply is only momentary.
The Bread Maker will operate again if its power is restored within 10 minutes, but the end
result may be affected.
My bread is sticky and slices
It was too hot when you sliced it.
unevenly.
Allow your bread to cool on rack before slicing to release the steam.
34
35
...Эта инструкция также подходит к моделям:
Хлебопечки - SD2500WXE (6.2 mb)
Хлебопечки - SD2501WXC (6.2 mb)
Хлебопечки - SD2501WXE (6.2 mb)