Installation: 1. Pull out the filter drawer all the way. 2. Insert the filter frame at an angle into the holder, fold up and attach by pressing the detent all the way. . If there are two grease filters, first insert the rear filter frame and then the front filter frame (profiled edge) into the filter drawer. Ensure that the grease filters are securely positioned on both sides. Filters and maintenance Activated carbon filter: For filtering odours during circulating-air mode. The activated carbon filter is installed above the grease filter(s) in the extractor hood. 1. Remove the grease filter(s) (see Filters and maintenance). 2. Insert the two enclosed plastic holders into the right and left sides of the extractor-hood housing and attach each holder with a screw (required only if installing an activated carbon filter for the first time). 3. Insert the activated carbon filter from below into the extractor-hood housing and lock into position on both sides. Ensure that the edge of the activated carbon filter is underneath. 4. Re-install the grease filter (see Filters and maintenance). Removal: The activated carbon filter is removed in reverse sequence. Press the locking hooks outwards. Replacing the activated carbon filter: During normal operation (1 to 2 hours daily), the activated carbon filter should be replaced approx. 1 x year. The activated carbon filter can be obtained from specialist retailers. . To ensure the best possible results, use only original filters. Disposal of the old activated carbon filter: . Activated carbon filters do NOT contain any pollutants, i.e. they can be disposed of as household rubbish. Cleaning and care For appliances with a glass plate in the pull-out vapour extractor: . The glass plate is easily removed and can be cleaned in a dishwasher. . To remove the lugs, push outwards. 1. 2. 3. 34 Replacing the light bulb 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. 2. Pull out the filter drawer all the way. 3. Pull the lamp cover forwards. 4. Replace the light bulbs. (Standard candle bulbs, max. 60 W, E14 socket). 5. Re-insert the lamp cover. 6. Plug appliance into mains again or switch on at the fuse box. Cleaning and care Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box. . At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. . Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood. . Do not scrape off any dirt that has dried on but loosen it up with a damp cloth. . Do not use abrasive cleaning agents or sponges that could cause scratches. . Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Caution: Ensure that the kitchen is adequately ventilated....

Эта инструкция также подходит к моделям:
Вытяжки - LI28030/07 (1.69 mb)
Вытяжки - 2MIB60S/05 (1.69 mb)
Вытяжки - 2MIB60S/06 (1.69 mb)
Вытяжки - 2MIB60S/07 (1.69 mb)