Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Important: Change the activated carbon filter promptly to prevent the risk of fire from the accumulation of heat when deep-fat frying or roasting. Filters and maintenance Installation: Attention: The halogen bulbs must be switched off and must have cooled down. 1. Remove the metal filters (see "Removing and inserting the metal grease filters"). 2. Insert the activated-carbon filters. To do this, connect the filters to the pins on the sides of the fan. Removing the filter: Attention: The halogen bulbs must be switched off and must have cooled down. 1. Remove the metal filters. 2. Rotate the filters against the direction of the arrow and pull them out. 3. Insert the metal grease filters. Replacing the activated carbon filter: . During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. . A replacement filter can be obtained from any authorized dealer. . Use original filters only. By doing so you will obtain maximum performance from your extractor hood. Disposing of the old activated carbon filter: . There are no pollutants in the activated carbon filters. They can therefore be disposed of as part of your normal domestic refuse. 3. Rotate the filters in the direction of the arrow until they engage. If the filters have been installed correctly, they can no longer be removed. 4. Insert the metal grease filters (see "Removing and inserting the metal grease filters"). Cleaning and care Isolate the extractor hood by pulling out the mains plug or switching off the fuse. Do not clean the extractor hood with abrasive sponges or with cleaning agents which contain sand, soda, acid or chlorine! . Clean the extractor hood with a hot soap solution or a mild window cleaner. . Do not scrape off dried-on dirt but wipe off with a damp cloth. . When cleaning the grease filters, remove grease deposits from accessible parts of the housing. This prevents the risk of fire and ensures that the extractor hood continues operating at maximum efficiency. . Note: Do not use alcohol (spirit) on plastic surfaces, as dull marks may appear. Caution: Ensure that the kitchen is adequately ventilated. Avoid naked flames! Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Do not use stainless-steel cleaner to clean the operating buttons. Stainless steel surfaces: . Use a mild non-abrasive stainless steel cleaner. . Clean the surface in the same direction as it has been ground and polished. . We recommend our stainless steel cleaner no. 461731. See enclosed service booklet for order address. Aluminium and plastic surfaces: . Do not use dry cloths. . Use a mild window cleaning agent. . Do not use aggressive, acidic or caustic cleaners. Observe the warranty regulations in the enclosed service booklet. Replacing the light bulbs 1. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. When switched on, the halogen bulbs become very hot. E...
Эта инструкция также подходит к моделям:Вытяжки - LC456CA30/02 (783.21 kb)
Холодильники - LF456CA30/01 (783.21 kb)
Холодильники - LF456CA30/02 (783.21 kb)