Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
• Never operate the extractor hood without grease filters. Correct installation • Check the manufacturer’s specifications for the cooker to determine whether an extractor hood can be operated over it. • If the manufacturer of the cooker has not specified any significant safety distances, the following minimum distances apply – 550 mmbetween electric hob and the lower edge of the extractor hood, Fig.1. – 650 mmbetween gas hob (upper edge of pan support) and the lower edge of the extractor hood, Fig.1. • If various cookers are used, the greatest indicated distance applies. • The width of the extractor hood must correspond to the width of the cooking area. • The extractor hood must not be installed over a solid fuel heating appliance which may be a fire risk (e.g. flying sparks) unless the heating appliance has a closed, non- detachable cover and the country-specific regulations are observed.This restriction does not apply to gas cookers and gas hobs. • To avoid damaging the hob, cover it when installing the extractor hood. Operating modes • The extractor hood can be used in exhaustAn activated carbon filter must be installed to air and circulating air mode. The standardbind odours in circulating-air mode (see setting is exhaust air mode.”Removing and installing the grease filters”). The complete installation set as well as the Exhaust-air mode The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system. Appliance dimensions Exhaust air replacement filters are available from specialist outlets, customer service or the Online Shop. The accessory number can be found at the end of the operating instructions. Appliance dimensions Circulating air Switching the electronic control to circulating air mode • The extractor hood must be connected and switched off. • Simultaneously press buttons0and+ until ais displayed. Circulating-air mode• Repeatedly press buttons0and+ to switch the electronic control back to exhaust air mode by (display#). The air which is drawn in is cleaned by the grease filters andan activated carbon filter and conveyed back into the kitchen. Operation Light Fan OFF Display for fan setting Fan follow-on Reduce fan speed Fan ON and increase speed Intensive setting NOTE: It is recommended to switch on the blower when you start cooking and not to switch it off again until several minutes after you have finished cooking. In this way the kitchen fumes are removed most effectively. Switching on the fan and selecting the fan settings • Press button +. If kitchen fumes are thicker, press button +again. The fan setting is increased by one. • To switch back by one setting, press button –. Switching off the fan • Press button 0. • The displayed 0 goes out shortly afterwards. Intensive setting The Intensive settingcgenerates maximum performance. It can be used if thick fumes or strong odours occur temporarily. • Keep pressing button +until cis displayed. • If the Intensive setting is not sw...
Эта инструкция также подходит к моделям:Вытяжки - LC259BA60/01 (2.84 mb)
Вытяжки - LC656BB60/01 (2.84 mb)
Вытяжки - LC956BB60/01 (2.84 mb)
Вытяжки - LC956WA60/01 (2.84 mb)