Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
at the end of the row of kitchen units). The extractor hood is designed for installation between two wall cabinets. 1. Remove grease filter (see Filters and maintenance) 2. Using the enclosed template mark the positions of the screws on the side panels of the neighbouring cabinets. 34342020 Installation The extractor hood can also be installed slightly lower, depending on the height of the wall cupboards. Position the template correspondingly lower. Observe the minimum distance from hob to extractor hood of 650 mm (the fixing screws must be fitted at least 1040 mm above the hob). 3. Predrill (with bradawl or 2 mm bit) and screw in the screws to 5 mm. Important: If the door of the unit is at a distance from the body of the unit (e.g. due to rubber stops), the extractor hood must be drawn forward by the same distance. 7. Mark the position of the lower fixing screws, predrill and fasten the screws. 8. All four fixing screws must be firmly tightened. 9. Connect pipes. 5 mm 4. Suspend the extractor hood on the two screws between the wall cabinets. 5. The two door carriers of the extractor flap must be pushed into the appliance to he stops. 6. Align the extractor hood with the leading edge of the side cabinets. 10. Connect electricity. Mounting the door: Door thickness: min. 16 mm Door height: 380 to 700 mm Door weight: 7 kg (max.) In order to match the wall cabinets on either side, the door can project at the top and bottom. min. 380max. 700600max.7kg 1. Remove the two door carriers to the right and left, by pulling both the red plastic catches inwards and removing the door carrier out towards you. 1.2. Installation 2. Mark the fixing points on the door. For dimensions of vertical screw fixings, see: + 412505702852852 If the top edge of the door is not flush with the top edge of the cabinet, amend the dimensions accordingly. If the tops of the cabinets are not installed flush with each other, the door must be mounted correspondingly higher. The screw locations on the door can be marked directly on the door in situ. If you are doing this, leave the door carriers in the appliance. Position the door, align it and mark the back. Keep precisely to the dimension 570 ± 2. 3. Screw the door carriers to the door, making sure your left-right orientation is correct. 4. Insert the complete door into the extractor hood Check that the door meets the stops on both sides when pulled out. This means that it is safely locked in place. The red plastic catches can only be released if the door is not swung out to the stop. 5. The two screws to the right and left inside the housing can be used to adjust door gliding according to the weight of the door. + Turning the screws clockwise will make the door more difficult to move. Mounting wall covering rail: The gap between the hood and the rear wall can be dressed with the enclosed covering rail. Screw-fasten the covering rail to the underside of the extractor hood. Refit the grease filter. If the unit door has to be removed:...
Эта инструкция также подходит к моделям:Вытяжки - D2615X0GB/01 (6.78 mb)
Вытяжки - D2615X0GB/02 (6.78 mb)
Вытяжки - D2615X0GB/03 (6.78 mb)
Вытяжки - D2616X0GB/01 (6.78 mb)