Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Initially, only LED 4 will flash, then after the 3 seconds have passed, LED 5 will also start flashing, indicating that the active carbon filter saturation control system is active. To switch off the system, re-press the same two buttons: after 3 seconds LED 5 will stop flashing and the device will be switched off. 6 -Intensive speed LED 7 -Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc.).The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button 1 or button 2. 8 -OFF lamp button 9 -ON lamp button If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once more before contacting the Technical Assistance Service. Filters and their maintenance Metal grease filter: The filter mat consists of noncombustible material . Caution: Increasing saturation with fatty residuals leads to enhanced flammability that can impair the function of the appliance. Important: Clean the metal grease filter in due time. Cleaning the metal grease filter: The metal grease filters must be washed at least once a month and anyhow whenever the LED 4 indicates the saturation of the filter. This LED warns you when the metal grease filter needs to be cleaned. This LED flashes to warn you that the metal grease filters must be cleaned. Generally, these must be cleaned after 40 hours of use. Once the grease filters have been cleaned, press button 1 for about3 seconds until you hear the acoustic signal (beep): the LED 4 will now stop flashing. • The cleaning can take place in the dishwasher. When you do so, a light discoloration can occur. Important: Densely saturated metal grease filters should not be cleaned together with other vessels. • When cleaning by hand soak for several hours in hot detergent suds. Afterwards brush off, rinse well and let it drip off. • Use original filters only. This assures optimal functioning. GB Removal and insertion of the metal grease filter Removal: Remove the metal grease filter using the handles designed for this purpose by pulling the filter backwards and then downwards. Installation: Proceed in reverse order. Active filter: For the absorption of odorous substances in recirculating operation. Mounting and replacing the active carbon filter: a) Disconnect the hood from the electricity. b) Remove the metal grease filters. c) If the active carbon filters have not been installed, place one active carbon filter on each side so that they cover the grates protecting the rotor on the motor. Then turn the center handle for the active carbon filters in the clockwise direction. rotor on the motor) and must be replaced, turn the central handle in the counterclockwise di...
Эта инструкция также подходит к моделям:Вытяжки - DKE975B/01 (337.69 kb)
Вытяжки - DKE975BGB(00) (337.69 kb)
Вытяжки - DKE975BGB/01 (337.69 kb)