Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
• Flat ductsmust have the same inner cross- section as round pipes. There should be no sharp bends. O 150 mm approx. 177 cm2 O 120 mm approx. 113 cm2 • If pipe diameters differ: Use sealing strips. Connection of 150 mm o exhaust air pipe (recommended size) • Attach exhaust air pipe directly to the air-pipe connector and seal appropriately. If using an aluminium pipe, smooth the connection area beforehand. Connection of 120 mm o exhaust air pipe • Attach reducing connector directly to the air-pipe connector. • Attach exhaust air pipe to the reducing connector. • Seal both joints appropriately. Electrical connection • Before connecting the appliance to the power supply, always follow the instructions and warnings in the chapter entitled ”Safety instructions”! • The extractor hood may only be connected by a qualified electrician who is familiar with the regulations of the relevant electricity supply company. . RISK OF INJURY • If the power cord of the extractor hood is damaged, it must be replaced by the manufacturer, his customer service or a similarly qualified person to prevent hazardous situations. • The extractor hood may be connected to a correctly installed earthed socket only. • Attach the earthed socket as directly as possible behind the flue duct. – The earthed socket should be connected via its own circuit. – If the earthed socket is no longer accessible following installation of the extractor hood, a disconnector must be fitted as for a permanent connection. If a permanent connection is required • A disconnector must be provided on the installation side. Switches with a contact opening of more than 3 mm and all-pole disconnection are regarded as disconnectors. This includes LS switches, fuses and contactors. Electrical specifications The required connection data can be found on the rating plate inside the appliance when the grease filters have been removed. Length of the power cord: approx. 1.30 m. This extractor hood complies with the EC interference suppression regulations. Installation The extractor hoodis designed for installation on the kitchen ceiling or on a rigid suspended ceiling. • During installation, optional accessories may also require fitting. • Observe the minimum distance between hob and extractor hood (see ”Safety instructions”)! • Avoid damaging the sensitive surfaces! Preparing the ceiling . RISK OF INJURY, DAMAGE TO PROPERTY Before drilling the holes for the designated installation location, check for concealed electrical cables and other lines. • The ceiling must be level and horizontal. • The enclosed screws and wall plugs are suitable for concrete and natural stone. Use the appropriate fasteners for other ceiling structures. Ensure that the ceiling has adequate load bearing capacity. • Ensure that the depth of the drilled holes corresponds with the length of the screws. • Ensure that the wall plugs are secure. Max. weight: 50 kg. Design subject to modification in line with technical development. Note: the extractor hood is to be installed to a kitchen ceiling or suspended ceiling. Ensure that the ceiling is capable of providing a firm hold for a maximum weight of hood and accessories of 45 kg. Before marking the securing holes, make sure that no electricity wires or water pipes or other wires/ pipes are laid at the drilling points in the ceiling. Before installation check the enclosed wall plugs and screws are suitable for your ceiling. If necessary use special wall plugs. Installation of the extractor hood: 1 Using the drilling template mark the position of the screws on the ceiling. 346200 2 Drill 4 holes O 8 mm for the wall plugs. Push the plugs flush with the ceiling. 3 Turn two screws to a 10 mm gap. Both screws are placed in a position, in which...
Эта инструкция также подходит к моделям:Вытяжки - AI400120/02 (2.84 mb)
Вытяжки - AI400150/01 (2.84 mb)
Вытяжки - AI400150/02 (2.84 mb)
Вытяжки - AI402120/01 (2.84 mb)