Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
DID YOU PROVIDE AN AIR-GAP AT THE DRAIN POINT? I • Install softener at point-of-entry into house before water heater. Needs to be within five feet of water inlet. • Install within ten feet of proper drainage; e.g. drain, standpipe or a sump which does not drain directly to outside. • Within ten feet of 120V, 60Hz electrical outlet-transformer must be plugged into an inside outlet. • All units must be installed according to local plumbing and electrical regulations. NOTE: Should not be installed in direct sunlight, freezing conditions, or where unit can get wet. For answers to your Monogram,® GE Profile Performance Series,” GE Profile” or GE appliance questions, call GE Answer Center® service, 800.626.2000. Created 7/98 GE Appliances GNSF35Z—GE SmartWater™ Softening System Features and Benefits • Grey / Round • Electronic-Demand Drive • GE Simple-to-Set Electronic Controls • Permanent Settings Memory • Super Capacity (35,000 grain capacity) • Demand-Initiated Regeneration • Efficiency (5168 gpg) • Maximum Hardness Removal (100 gpg) • Maximum Iron Reduction (6 ppm) • Standard Mesh Resin Filter • 24 Volt Electronic System • Salt Storage Capacity (200 lbs.) • Water Used for Regeneration (40-50 gallons) • Regneration Time (118 minutes) • Installation Kit, Bypass Valve and Drain Tubing Included • Model GNSF35Z - Grey Created 7/98...