Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
550-141-830/1202 Read This Page First Read This Page First Hazard Definitions Following terms are used to bring attention to the presence of hazards of various risk levels, or to important information concerning product life. Indicates presence of hazards that will cause severe personal injury, death or substantial property damage if ignored. Indicates presence of hazards that can cause severe personal injury, death or substantial property damage if ignored. Indicates presence of hazards that will or can cause minor personal injury or property damage if ignored. Indicates special instructions on installation, operation, or maintenance that are important but not related to personal injury hazards. Symbol Definitions These symbols indicate information for and procedures to be followed by: Homeowner or person responsible for simple start-up and routine maintenance of boiler and system. Pages 2 through 6 must be followed to assure proper operation of your boiler. Page 7 lists common problems and possible corrections. In addition, it is your responsibility to: . Have boiler and burner installed by a qualified installer. . Have boiler and burner serviced annually by a qualified service technician. . Review and understand start-up and routine maintenance procedures with qualified service technician. . Perform routine maintenance as described on page 4. Qualified service technician who has the necessary equipment to check the boiler and system performance, and is responsible for start-up and service of boiler and system. Pages 2 and 3 and 8 through 11 must be followed to assure proper operation of this boiler. In addition, it is the responsibility of this person to: . Annually service boiler and burner to assure proper operation. See page 8 for service record. . Review and explain start-up and routine maintenance procedures with homeowner. Part No. 550-141-830/1202 For Your Safety For Your Safety Follow instructions below to Tips for steam systems: prevent severe personal injury, death or substantial property damage: . Do not use crankcase drainings or any oil containing gasoline. See burner manual for proper fuel oil. . Do not attempt to start burner when excess oil has accumulated in combustion chamber, when unit is full of vapor, or when combus tion chamber is very hot. . Do not start burner unless collector hood, flue cap, jacket cap, breeching and burner mounting door are secured in place. . Never burn garbage or paper in the boiler. . Never leave combustible material around boiler. . DO NOT TAMPER WITH UNIT OR CONTROLS. Always follow specific instructions when starting up boiler or performing routine maintenance or service. Follow instructions below to prevent severe personal injury, death or substantial property damage: . To avoid electric shock, turn off electrical supply at switch on boiler and additional external switches before performing service. . To avoid severe burns, allow boiler to cool before performing service. . Do not block flow of combustion or ventilation air to boiler. . Boiler must be connected to a flue with sufficient draft at all times to assure proper operation. . Do not use this boiler if any part has been under water. Electrical and mechanical failures may cause electric shock and fire risks. Immediately call a qualified service technician to inspect chimney or vent, boiler and burner. Have the boiler flueways cleaned and have the following replaced: — all electrical and mechanical controls — electrical wiring — oil burner and controls — insulation and chamber lining . Check boiler and system piping for leaks. Continual makeup water will reduce boiler life. Minerals can build up in sections, reducing heat transfer and causing cast iron to overheat, resulting in section failure. Failure to maintain recom mended pH and to repair leaks can cause section iron corrosion, leading to section failure and leaks. Do not use petroleum- based sealing or stop-leak compounds in boiler systems. Damage to system components can result. . Boiler water pH 7.0 to 8.5 is recommended. For pH conditions outside 7.0 to 8.5 range or unusually hard water areas (above 7 grains hardness), consult local water treatment company. . Do not add cold water to hot boiler. Thermal shock can cause sections to crack. . Clean newly installed steam boiler to remove oil, grease, and other foreign material. Failure to properly clean can result in violent water level fluctuations, water passing into steam mains, or high maintenance costs on strainers, traps and and vents. A qualified service technician should skim the boiler by following instructions on page 10 of this manual. Part No. 550-141-830/1202 Routine Maintenance Schedule Routine Maintenance Schedule The schedule below is specifically designed for the homeowner. Please read pages 2 and 3 before proceeding. Beginning each heating season: . Call a qualified service technician to perform annual service. Daily during heating season: . Check that boiler area is free from c...