For closed operations, if the safety valve is not directly above the drain, then the drain pipe must be mounted at a continuous downward slope in a frost-free environment. Operating Modes Single Power Operation Connection without off-peak contact. The appliance heats with the adjusted performance. The 'fast-heating' button is only used for the reset and diagnose functions. Connection with off-peak contact If the 'fast-heating’ button is activated, the device heats once to the configured temperature. All 6 LED thermal capacity indicators light up as soon as the configured temperature has been reached. Afterwards, the device turns itself off automatically. Double Power Operation Connection without off-peak contact. The reservoir heats with the configured basic performance. The “fast-heating function” activates a heating cycle at higher installed power in order to accelerate the heating-up procedure. To start this function, press the fast-heat button . The LED fast-heating' lights up. The function turns itself off automatically, as the soon as the configured temperature has been reached. The LED 'fast-heating' turns off . Connection with off-peak contact During off-peak time the device heats with the configured basic performance. The “fast-heating function” activates a heating cycle at higher power in order to accelerate the heating-up procedure. To start this function, press the fast-heat button . The LED 'fast-heating' lights up. The function turns itself off again automatically as soon as the configured temperature has been reached. The LED fast-heating' turns off. The rest of the time, the device does not heat. If the 'fast-heating' button is activated, the device heats once to the configured temperature. All 6 LED thermal capacity indicators light up as soon as the configured temperature has been reached. Afterwards, the device turns itself off automatically. Boiler Mode Connection without off-peak contact. The device does not heat by default. If the 'fast-heating' button is activated, the device heats once to the configured temperature. All 6 LED thermal capacity indicators light up as soon as the configured temperature has been reached. Afterwards, the device turns itself off automatically. Each further heating process must be started by pushing the button “fast-heating” . Electrical Connections Danger of electric shock! The power switch “S1” may only be activated in an unpowered state!! Remove lower cap by taking the screws out (page IV, diagram 13, 13.1). Lead cable through the cable gland and cord grip and connect, then tighten the cable gland and cord grip (page V, diagram 14). Check that the system is suitable for the maximum power absorbed by the water heater (please refer to the data plate) and that the cross-section of the electrical connection cables is suitable, and no less than 2.5 mm2 . Operating mode Set the power switch “S1” to the correct operating mode on the electronic board. Set the desired load according to the connection e...

Эта инструкция также подходит к моделям:
Водонагреватели - DG10025/13 (2.87 mb)
Водонагреватели - DG10025/14 (2.87 mb)
Водонагреватели - DG12025/11 (2.87 mb)
Водонагреватели - DG12025/13 (2.87 mb)