Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
The water heatershall be wall-mounted. Before installation, make sure water heater rear wires are fit firmly. Determine an installation location. Make four holes 12mm, 65 mm deep in the wall with an impact drill according to installating dimension. Insert fixexpansion hooks and expansion bolts in corresponding wall holes. Lift the water heater. Insert wall rack onto the hooks and bolts. Fit flat washers, rear wires and nuts in turn onto the bolts (see Figure 2). Tighten the nuts and check them firm. Install accessories such as safety valve, drain hose as shown in Figure 3. Use sealing compound to prevent water leakage. (Figure 2) To facilitate installation and removal, it is suggested a G 1/2" movable nut is fitted at appropriate locations on inlet and outlet pipes respectively. Find water supply location. Connect inlet pipe, outlet pipe and city water pipe respectively to the use point. The hot water pipe shall not be too long to reduce the heat losses. Please reserve some space in installation for the future maintenance. ...
Эта инструкция также подходит к моделям:Водонагреватели - FCD-JTHA40-III, FCD-JTHA50-III, FCD-JTHA60-III (1.71 mb)