2.) Drill a suitable hole through the wall at selected sensor location. Route sensor wires through wall, making sure they are accessible from the inside. Use provided spacers to stand off plate from wall. Mount the sensor plate loosely to wall with only 1 screw so that access to hole is preserved for application of caulking. Fill hole with a suitable exterior caulking compound. Then insert second screw and tighten both screws carefully. From inside, locate sensor wires and wires from thermostat.

Activation of Quick Configuration loads settings directly into EEPROM. These settings will remain in effect until a unit is reconfigured. 1. Click Quick Configuration on the General tab, click it on the toolbar, or select it from the Commands menu. The Quick Configuration wizard appears with the Operating Mode window displayed. 2. Select the desired Operating Mode. 3. Select Broadcast (Host) for a network configuration of 2 or more transceivers on a Broadcast network. When configuring slave mode

4. Attach the male connector on the RS-232 cable to the matching serial port on the rear panel of the transceiver. 5. Connect the other end of the RS-232 cable to the matching serial port on the device. 2 Table 1 — Hardware Specifications Frequency 2.400-2.4835 GHz license-free ISM band in U.S. (varies in other countries where transceivers have been certified) Radio Type Frequency Hopping Spread Spectrum Number of Channels 417 independent, non-interfering frequencies Data Rate 600 bps to 9.6 kbp

Carrier transceivers are designed to be used only with certain antenna products. Other higher gain directional antennas may be purchased through an approved Carrier supplier. Contact Carrier for additional information. Installation onto a CCN Bus — Use the RS-232 to RS-485 converter to install transceivers directly onto an RS-485 network. An RS-232 to RS-485 converter and power supply is supplied with each transceiver. 1. Separate the RS-485 converter’s housing with a flat blade screw driver. 2.