Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
@ Black clamp connects to any iron part of car. Use the red pen to test every power line from the power detecting pen (G) Cut off the power of car. reverse light until the LEO light is on. Then you can ensure that this is the power line. (7) Connect the filter(D)(the"IN"side) to the reversing (g) Connect the camera power lines to the filter(D)(the (9) Connect the power lines as before, light power line, anode to anode, cathode to cathode, 'OUT'side), anode to anode, cathode to cathode, then fix the cables with the rubberized fabric. then fix the cables with the rubberized fabric. (îç) Enlace and hind other lines properly. 4. Installation of wireless receiver (D Black clamp connects to any iron part of car. Use the red pen to test every power line from the reverse light until the LED light is on. Then you can ensure that this is the power line. (3) Connect the power line of the wireless receiver box to the reverse light power line. And then connect the power line of the car as before. (4) Connect the power line to the wireless receiver box. And connect other cables as instruction. Hide the wireless receiver box to the place where doesn't affect driving. 5. Camera function introduction Specification Mager 1/3 DSP Color CCD Effective pixels 512(H) x582(V) Horizontal resolution 420TV lines Total number of pixels 3200.000 Min.illmination 0.5 Lux at F2.0 Synchronizing system Internal Scanning system 2:1 interlaced Video output lVp-p 75ohm S/n ratio More than 48db Electronic iris 1/50 to 1/1000 sec White balance AUTO Gain control AUTO Lens mount 2.8 mm pinhole lens Power source DC 12 V Operating temp -4°F— + 122°F(-20°C— + 50 °C) Storage temp -40°F~ + 176°F(-40°C ~ + 80°C) Waterproof IP67 Camera with built-in wireless transmitter 2.4G wireless frequency 6. Receiver box function introduction Specifications: 1.CCD camera with built-in wireless transmitter 2.Wireless transmission frequency:2.4G main channel (Channel 4th was set in the factory if no special requirement) 3.Current consumption: Wireless receiver: 180mA Transmitting type FM Output image standing wave ratio 2 : 1 Transmission power 9 dBm Video input 1Vp-p 75 Ohm Audio input 1Vp-p 600 Ohm Audio minus carrier wave 6.5MHz Current consumption 100 mA(max) Working temperature - 30°C~80°C ( Humidity<95%) Storage temperature -40°C—100°C ( Humidity<95%) 7. Testing When the reverse gear is engaged, the system works automatically. The wireless camera at the back of car will send signals to the wireless receiver box in front of car. Testing after installation: First, ensure that the monitor is on when the VCD is on, monitor will show the images of VCD; When reverse gear is engaged, monitor will change to the images from the CCD camera automatically. After the testing is finished, system will come back to the original status....
Эта инструкция также подходит к моделям:Видеонаблюдение - VTX400 (944.11 kb)