Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
Extend the viewfinder straight out, then adjust the viewfinder focusing lever to suit your eyesight. • The viewfinder extends straight out for comfortable viewing. Store the camera with the viewfinder flush with the body of the camera. • To view with the viewfinder, make sure the LCD panel is either turned so that the subject can monitor viewing, or totally closed with the screen facing inwards. Adjust the viewfinder Prepare the lens cap • Attach the cord to the lens cap, and pass the grip belt through the loop on the cord. • Hook the lens cap on to the grip belt while you are recording, and place it over the lens when you have finished. Fasten the grip belt • Release the Velcro fastening and hold the camera with your right hand while you adjust the belt with your left. Your index finger should reach the zoom control and photo button, and your thumb should reach the start/stop button comfortably. • When holding the camera, be sure to avoid touching the lens and the microphone. Notes on Using the Batteries Charging and recording times • These times vary — the safest policy is always to have 2 or 3 times as many battery packs as you think you will need. • You will get more recording time if you turn the camera off between shots, instead of leaving it in record pause mode. Battery pack BP-406 BP-412 BP-422 (optional) (optional) E Time needed for 1 hr. 10 min. 2 hr. 1 hr. 50 min. full recharge Maximum Using the viewfinder: 55 min. 1 hr. 40 min. 3 hr. 20 min. recording time Using the LCD screen: 45 min. 1 hr. 20 min. 2 hr. 45 min. • Recording time will be shorter than usual at low temperatures. You can use the battery pack between 32° and 104°F (0° to 40°C), but it works best between 50° and 86°F (10° to 30°C). • If the battery pack starts to give you much less operating time than usual (at normal temperatures), it has reached the end of its life and must be replaced. • These figures show how long you can view playback with the LCD, after attaching a fully-charged battery pack. Playback time will be shortened at low temperatures. Battery pack Playback time (using the LCD screen) BP-406 55 min. BP-412 1 hr. 20 min. BP-422 3 hr. 20 min. How much power is left? The indicator in the display shows you 100% approximately how much charge the battery pack has left: v v v 75% 50% 25% • “CHANGE THE BATTERY PACK” appears in the display for 4 seconds when the power is completely exhausted. The empty battery mark then appears and starts to flash. The power indicator light also flashes. • The indicator is not constant — different levels will be shown when you subject the battery pack and camcorder to different conditions. AdditionalInformation v CHANGETHEBATTERYPACK 0% 122 When to recharge You can recharge a lithium ion battery pack whenever it is convenient. Unlike a conventional battery pack, it does not have to be fully discharged first. However, as the battery pack will naturally discharge itself over time, it is best to charge it the same day you plan to use it, or the day before. Taking care of the battery pack Always attach the terminal cover. • Do not allow any metal objects to touch the terminals, as this can cause a short circuit and damage the battery pack. Attach the terminal cover whenever the battery pack is not being used. Keep the terminals clean. • Make sure no foreign objects get between the terminals as this can cause a short circuit and damage the battery pack. Attach the terminal cover whenever the battery pack is not being used. Storing the battery pack • If you do not use a battery pack for a period of more than a few months any remaining charge may cause damage to the battery pack, and reduce usage time. To prevent damage therefore, aim to use a battery pack’s complete charge before storage. See the optional battery pack’s instructions for further details. E Additional Information 123 E Installing the backup battery Open the cassette compartment cover. The cassette compartment will open automatically. If necessary, close it to give yourself more room to install the backup battery. Insert the CR1616 lithium battery as far as it will go with the + side facing outwards. Make sure the cassette compartment is closed and close the cassette compartment cover. This backup battery allows the camera to remember the date and time and other settings when main power source is removed. It has a life span of about a year. When it needs replacing (or if it has not been installed), the y mark flashes in the display. Press the old battery and slide it up to remove. DANGER! Treat the battery pack with care. • Keep it away from fire (or it might explode). • Do not expose the battery pack to temperatures greater than 140°F (60°C). Do not leave it near a heater, or inside a car in hot weather, for example. • Do not try to disassemble or modify it. • Do not drop or knock it. • Do not get it wet. WARNING! • The battery used in this device may present a fire or chemical burn hazard if mistreated. Do not recharge, disassemble, ...
Эта инструкция также подходит к моделям:Видеокамеры - Elura 20MC (3.7 mb)