Оценок - 4, средний балл: 4
(
)
)
|
Фото и характеристики Sony MHS-FS3 |
К этому устройству также есть другие инструкции:
Фрагмент инструкции
– Bloggie Software (application software) – Bloggie Handbook (this manual) • Instruction Manual (1) • Important Notice (1) 21GB contents Operation Search Menu/Settings Search Index Charging the camera The camera’s battery is continuously charged whenever the camera is connected to a running computer. 1Press the ON/OFF (Power) button to turn off the camera. 2Slide the slide lever at the side of the camera. The USB jack comes out as shown in the illustration. 3Connect the camera to the computer that is turned on. The charge lamp lights up in orange, and charging starts. When the charge lamp turns off, charging is finished. ON/OFF (Power) button USB jack Slide lever • The charge lamp may turn off when the temperature is outside of the recommended operating temperature (10°C to 30°C (50°F to 86°F)). Charge lamp 22GB Continued r 4 4camera and computer (page 23). Install Bloggie Software (pre-loaded on the internal memory) after completing the procedure above. Notes • While the camera is connected to a computer, you cannot operate the camera. Be sure to disconnect the camera before operation. • Do not apply force to the camera, when you connect the camera to a computer. This may cause damage to the camera or the computer. • When you connect the camera to a notebook computer that is not connected to an AC power source, the battery of the notebook computer may be depleted rapidly. Do not leave the camera connected to the computer for a long time. • Charging the battery or the connection with customized or hand-built computers is not guaranteed. Depending on the type of the USB device used, charging may not function properly. • If you do not intend to use the camera for an extended period, charge the camera once every 6 to 12 months to maintain battery performance. Disconnecting the USB connection Perform the procedures from step 1 to 3 below before: • Disconnecting the USB connection support cable. • Turning off the camera. 1 Double-click the disconnect icon on the Windows Vista tasktray. 2 Click (USB Mass Storage Device) t [Stop]. 3 Confirm the device on the confirmation window, then click [OK]. Windows XP Disconnect icon Note • Drag and drop the drive icon to the “Trash” icon beforehand when you use a Macintosh computer, and the camera is disconnected from the computer. zTo retract the USB jack Push the USB jack back in the direction of the arrow until it clicks. Table of contents Operation Search Menu/Settings Search Index 23GB Continued r contents Operation Search Menu/Settings Search Index zHow long does it take to charge the camera? Charging time • Time required to charge a fully depleted battery at a temperature of 25°C (77°F). Charging may take longer under certain circumstances or conditions. Full charge time Approx. 200 min. zHow long can I record or play back images? Standard battery life *1 Recording time is the time when shooting movies in 3D. *2 Continuous recording time shows the approximate time available of a fully charged battery pack. Continuous recording of movies is possible for approximately 29 minutes. Also, recording stops automatically to prevent the file size from exceeding 2 GB. *3 Typical recording time shows the approximate time available of a fully charged battery pack when you repeatedly execute operations, such as setting to shooting mode, turning on/off the power, or zooming. Recording time*1 Continuous recording time*2 Approx. 60 min. Typical recording time*3 Approx. 40 min. Playback time Approx. 120 min. zChecking the remaining battery charge A remaining charge indicator appears on the upper right of the LCD screen. • The displayed battery remaining indicator may not be correct under certain circumstances. • If the camera is running on battery power and you do not operate the camera for about 5 minutes, the camera turns off automatically to prevent wearing down the battery (Auto power off function). • The Language/Clock Setting screen appears when the camera is turned on for the first time (page 28). • It takes about one minute until the correct battery remaining indicator appears. High Low 24GB contents Operation Search Menu/Settings Search Index Installing the software You can do the following using the Bloggie Software (pre-loaded on the internal memory). – Import images shot with the camera to a computer, and play back. – Upload images to a network service. 1Press the ON/OFF (Power) button to turn on the camera. 2Slide the slide lever at the side of the camera. ON/OFF (Power) button Slide lever USB jack 3 Connect the camera to the computer that is turned on. When the USB connection is completed, the Mass Storage screen appears on the LCD screen of the camera. 25GB Continued r 4 4 Windows 7 1 Click [Open folder to view files] on the AutoPlay screen. Table of contents Operation Search Menu/Settings Search Index 2 Double-click “Setup_Bloggie_Windows.exe” in the folder. Windows Vista/Windows XP 1 Click [Setup Bloggie Software] on the AutoPlay screen. • If the AutoPlay screen does ...
Эта инструкция также подходит к моделям:Видеокамеры - MHS-FS3K (1.58 mb)