Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
3 Insert the Battery Holder into the Remote Control. • When the button-type battery is exhausted, replace it with a new CR2025 battery. (A battery is normally expected to last about 1 year. However, it depends on operation frequency.) • Make sure to match the poles correctly when inserting the button-type battery. WARNING .Replace Battery with Panasonic or Lixing type CR2025 only. Use of another battery may present a risk of fire or explosion. .Battery may explode if mistreated. .As with any small object, this type of Battery can be swallowed by young children. Do not allow children to handle this Battery. CAUTION .Dispose of used battery promptly. .Do not recharge, disassemble or dispose of in fire. Using the Remote Control (PV-GS35 Only) 1 Direct the Remote Control at the Remote Control Sensor 15 of the Camcorder and press an appropriate button. 15° 15° 15° 15° 15 • Distance from the Camcorder: Within approximately 15 feet (5 meters) • Angle: Within approximately 15° in the vertical and horizontal directions from the central axis • The above operating ranges are for indoor use. Outdoors or under strong light, the Camcorder may not operate properly even within the above ranges. • Selecting Remote Control ModesWhen 2 Camcorders are used simultaneously, they can be operated individually by selecting different Remote Control Modes. • If the Remote Control Mode of the Camcorder and that of the Remote Control do not match with each other, [REMOTE] will appear. When the Remote Control is operated for the first time after the Camcorder is turned on, [CHECK REMOTE MODE] (p. 58) will appear and operation is impossible. Set the same Remote Control Mode. For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: Before Using • Setup on the Camcorder Set [ REMOTE] on the [ SETUP] Sub-Menu to the desired Remote Control Mode. (pp. 22, 23) • Setup on the Remote Control 12 [VCR1]: Press the [.>] Button and [ ¦ ] Button simultaneously. 1 [VCR2]: Press the [<.] Button and [ ¦ ] Button simultaneously. 2 • When the battery in the Remote Control is replaced, the mode is automatically reset to [VCR1] Mode. Power Supply Using the AC Adaptor 1 Connect the DC Cable to the Camcorder. 2 Connect the DC Cable to the AC Adaptor. 3 Connect the AC Cable to the AC Adaptor and the AC Jack. • Before connecting or disconnecting the power supply, set the [OFF/ON] Switch 28 on the Camcorder to [OFF] and make sure that [POWER] Lamp 32 is not lit. (p. 18) Using the Battery Before use, fully charge the Battery. • We recommend using a Panasonic Battery. • We cannot guarantee the quality of this Camcorder when batteries from other companies are used. 1 Attach the Battery to the AC Adaptor and charge it. 2 Put the Battery on the Battery Mount by aligning the mark, and then securely plug it in. • Since the Battery will not be charged when the DC Cable is connected to the AC Adaptor, disconnect it from the AC Adaptor. • The [CHARGE] Lamp lights up, and charging starts. • When the [CHARGE] Lamp goes off, charging is completed. • When the battery is completely discharged, the [CHARGE] Lamp blinks at first, but the battery is charged normally. When the temperature of the battery is too high or low, the [CHARGE] Lamp blinks and the charging time becomes longer than usual. 3 Attach the charged Battery to the Camcorder. • Disconnecting the Power SourceSet the [OFF/ON] Switch 28 to [OFF], and while sliding the [BATTERY RELEASE] Switch 39 , remove the Battery downward or DC Cable. • When attaching or removing Battery, set the [OFF/ON] Switch to [OFF] and make sure the [POWER] Lamp is not lit. 28 39 • Hold down the battery with your hand so it does not fall. • For other notes concerning this item, see page 59. 16 For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: Before Using Charging Time and Available Recording Time A Charging Time Maximum Continuous Recording Time Intermittent Recordable Time B • “1 h 40 min.” indicates 1 hour and 40 minutes. • Battery CGR-DU06 (PV-GS19/PV-GS31) or CGA-DU12 (PV-GS35) is supplied. • The times shown in the table are approximate times. The numbers indicate the recording time when the Viewfinder is used. The numbers in parentheses indicate the recording time when the LCD Monitor is used. In actual use, the available recording time may be shorter. • The times shown in the table are for continuous recording at a temperature of 68 °F (25 °C) and humidity of 60 %. If the Battery is charged at a higher or lower temperature, the charging time may be longer. • We recommend the Battery Pack CGA-DU12 and CGA-DU21 for long time recording (2 hours or more for continuous recording, 1 hour or more for intermittent recording.) • The available recording time becomes shorter if you use both of Viewfinder and LCD Monitor simultaneously when rotating the LCD Monitor forward to record yourself. • The batteries heat up af...