Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
~~~~~~~~~~~~~~~~~~~~~~~~~ Audio Dubbing You can add music or narration to the recorded Cassette. .If you perform audio dubbing onto a tape that was recorded with [AUDIO REC] on the [RECORDING SETUP] Sub-Menu of the [CAMERA FUNCTIONS] Main-Menu set to [16bit], the original sound is erased. (If you want to preserve the original sound, use the [12bit] Mode when recording.) .Audio Dubbing cannot be performed onto recordings made in LP Mode. (l23) 1 Set [VCR FUNCTIONS] >> [AV IN/OUT SETUP] >> [AV JACK] >> [IN/OUT]. 2 Continuing the aforesaid setup, select [A.DUB INPUT] >> [MIC] or [AV IN]. .Set to [AV IN] when external device is used, and to [MIC] when an external or built-in microphone is used. .Switch the Palmcorder over to the Still Playback Mode where you want to add new sound track. 3 Press the [A.DUB] Button on the Remote Controller. .[A.DUB;] Indication appears. 1 4 To start Audio Dubbing, press the [;] Button on the Remote Controller. .[A.DUB!] Indication appears. 2 To Stop Audio Dubbing Press the [;] Button on the Remote Controller. The Palmcorder is in the Still Playback Mode again. To dub audio while listening to a pre-recorded sound When pausing the audio dubbing, [12bit AUDIO] on the [PLAYBACK FUNCTIONS] Sub-Menu is automatically set to [ST2] and you can check the pre-recorded sound. When a microphone is used for audio dubbing, use headphones to listen to the pre-recorded sound while dubbing the audio. (When using headphones, set [AV JACK] on the [AV IN/ OUT SETUP] Sub-Menu to [OUT/PHONES].) When the line input is used, you can dub audio while listening to a pre-recorded sound from the speaker. Playing Back the Sound Recorded with Audio Dubbing (For 12 bit Audio Recording) Set [VCR FUNCTIONS] >> [PLAYBACK FUNCTIONS] >> [12bit AUDIO] >> [ST2] or [MIX]. ST1: Play back only the original sound. ST2: Play back only the sound added by Audio Dubbing MIX: Play back both the original sound and the sound added by Audio Dubbing simultaneously. .For other notes, see page 70. 41 Special Features 1, 2 F 7 640 PICTURE 14MPEG4 2VOICE 33 MENU 5 4 PHOTO SHOT CARD MODE TAPE CARD 56PUSH SHUTTER/IRIS/ VOL/JOG A1 2 13 Using a Memory Card An SD Memory Card or MultiMediaCard can be used to record files or play back files. .Use a genuine SD Memory Card or MultiMediaCard manufactured by Panasonic only. .Inserting a Memory Card Before inserting a Memory Card, be sure to turn off the Palmcorder. 1 Open the Card Slot Cover. 2 While holding the Memory Card with its cut corner A facing right, insert it into the Card Slot. 3 Close the Card Slot Cover securely. .Removing the Memory Card Open the Card Slot Cover, press the center of the Card and then pull it straight out. .After removing the Card, close the Card Slot Cover. .The Palmcorder or the Card may be damaged if the Card is forced out when the Card is fully inserted. .[ACCESS] Lamp While the Palmcorder is accessing the Card (reading, recording, playback, erasing, moving of images), the [ACCESS] Lamp 1 lights up. .While the [ACCESS] Lamp is on, never attempt to: pull out the Card, to turn off the Palmcorder power, or switch the [TAPE/CARD/CARD MODE] Selector. Such actions will damage the Card and cause the Palmcorder to malfunction. ~~~~~~~~~~~~~~~~~~~~~~~~ Recording on theMemoryCard 3 kinds of data can be recorded by selecting with the [TAPE/CARD/ CARD MODE] Selector. When recording a still picture, slide the [TAPE/ CARD/CARD MODE] Selector until the [PICTURE] Indication 1 appears (Card PhotoShot), when recording a moving picture, slide the [TAPE/CARD/ CARD MODE] Selector until the [MPEG4] Indication 2 appears (MPEG4 Recording), when recording voice, slide the [TAPE/CARD/CARD MODE] Selector until the [VOICE] Indication 3 appears (Voice Recording). .For other notes, see page 70. .Card PhotoShot Still pictures can be recorded on the Memory Card from the Palmcorder lens as well as from scenes that have already been recorded on a cassette. The size of images that are recorded using this Palmcorder is approximately 3,000,000 pixels. Recording of images with a size that is larger than a million pixels is called mega-pixel still-picture recording. Compared to images of normal recording, images that are created by mega-pixel still-picture recording can be printed out more clearly. Recording from the Palmcorder Lens (CAMERA Mode) 1 Slide the [TAPE/CARD/CARD MODE] Selector to [CARD]. 2 Slide the [TAPE/CARD/CARD MODE] Selector to [CARD MODE] until the [PICTURE] Indication appears. .Remaining Number of Card PhotoShot pictures 4. 3 Set [CAMERA FUNCTIONS] >> [CARD SETUP] >> [PICTURE SIZE] >> [2048t1496] or [640t480]. 4 Center the subject in the focus area 5 on the screen. .In Auto Focus Mode, the focus indication 6 is lit when the subject is in focus. (Green: in focus, White: roughly in focus) 5 Press the [PHOTO SHOT] Button. .The [ PICTURE ] Indication will light in red. .For other notes, see page 70. Concerning Low Light Shot When recording dark scenes, set the [LOW LIGHT SHOT] of the [C...