Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Provided the care and maintenance guidelines described in this document are strictly followed, this unit can operate underwater, to a depth not exceeding 3 m (10 feet) for a time not exceeding 60 minutes. (*1) Anti-shock Performance This unit also complies with “MIL-STD 810F Method 516.5Shock”. This unit has cleared a drop test from a height of 1.5 m (5.0 feet) onto 3 cm (0.10 feet) thick plywood. In most cases this unit should not sustain any damage if dropped from a height not exceeding 1.5 m (5.0 feet). (*2) This does not guarantee no destruction, no malfunction, or waterproofing in all conditions. *1 This means that this unit can be used underwater for specified time in specified pressure in accordance with the handling method established by Panasonic. *2 “MIL-STD 810F Method 516.5-Shock” is the test method standard of the U.S. Defense Department, which specifies performing drop tests from a height of 122 cm (4.0 feet), at 26 orientations (8 corners, 12 ridges, 6 faces) using 5 sets of devices, and passing the 26 orientation drops within 5 devices. (If failure occurs during the test, a new set is used to pass the drop orientation test within a total of 5 devices.) Panasonic’s test method is based on the above “MIL-STD 810F Method 516.5-Shock”. However, the drop height was changed from 122 cm (4.0 feet) to 150 cm (5.0 feet) dropping onto 3 cm (0.10 feet) thick plyboard. This drop test was passed. (Disregarding appearance change such as loss of paint or distortion of the part where drop impact is applied.) 10 VQT3N87 . Handling of this unit . Waterproofing is not guaranteed if the unit is subject to an impact as a result of being hit or dropped etc. If an impact to this unit occurs, it should be inspected (subject to a fee) by a Panasonic’s Service Center to verify that the waterproofing is still effective. . The waterproof performance may be degraded due to the strong water pressure when this unit is used deeper than 3 m (10 feet) underwater. . When this unit is splashed with detergent, soap, hot spring, bath additive, sun oil, sun screen, chemical, etc., wipe it off immediately. . Waterproof function of this unit is for sea water and fresh water only. . Any malfunction caused by customer misuse, or mishandling will not be covered by the warranty. . The inside of this unit is not waterproof. Water leakage will cause malfunction. . Supplied accessories are not waterproof. . Cards are not waterproof. Do not handle with a wet hand. Also, do not insert wet card into this unit. . Do not leave this unit for a long period of time in places where temperature is very low (at ski resorts or at high altitude etc.) or very high [above 35 oC (95 °F)], inside a car under strong sunlight, close to a heater, on the beach, etc. Waterproof performance may be degraded. . Foreign objects may adhere to the inner side of the door/cover (around the rubber seal or connecting terminals) when the door/ cover is opened or closed in places with sand or dust etc. This may result in the impairment of the waterproof performance if the door/cover is closed with foreign objects adhered. Be extremely careful since it may result in malfunction etc. . If any foreign object is adhered to the inner side of the door/cover, remove with a lint-free cloth. . If any liquid such as water droplets is adhered to this unit or inner side of the door/cover, wipe off with a soft dry cloth. Do not open or close the door/cover near the water, when underwater, using wet hands, or when this unit is wet. It may cause water leakage. VQT3N87 11 . When inner side of the lens is fogged (condensation) It is not a malfunction or failure of this unit. It may be caused by the environment in which this unit is used. What to do when inner side of the lens is fogged . Turn off the unit and open the door/cover in a place with constant ambient temperature, away from high temperatures, humidity, sand and dust. The fog will disappear naturally in 10 minutes to 2 hours with the door/cover open when the temperature of this unit gets close to the ambient temperature. . Contact Panasonic’s Service Center if the fogging does not disappear. Conditions in which inner side of the lens may be fogged Condensation may occur and the inner side of the lens may be fogged when this unit is used in areas that undergo a significant change in temperature or in high humidity, such as the following: . When this unit is used underwater suddenly after being on a hot beach etc. . When this unit is moved to a warm area from a cold area, such as at a ski resort or at high altitude . When the door/cover is opened in a high-humidity environment Check before using underwater Do not open or close the door/cover in places with sand and dust, close to water, or with wet hands. Sand or dust adhering may cause water leaks. 1 Check that there are no foreign objects on the inner side of the door/cover. . If there is any foreign object, such as lint, hair, sand, etc., on the surrounding area, water will leak...