Оценок - , средний балл: ( )

Инструкция по эксплуатации Audiovox, модель 50-0263x-018 SERIES

Производитель: Audiovox
Размер: 467.28 kb
Название файла:

Язык инструкции:

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Документ загружается, подождите пожалуйста

Скачать инструкциюЗакрыть

Route video and audio cables to passenger’s side rear of vehicle. Using a razor knife, carefully cut a slit in carpet to allow cables to pass through. Make sure wiring will not rub against edge of bracket. Position VCP mounting bracket (item 3 pg 2) against side panel and 1 1/8" from back edge of ledge on side panel as shown. Make sure bottom of bracket is firmly resting on floor of vehicle. Mark the center of slot on side panel. See Figure 1. FIGURE 1 2. Carefully drill a 3/8" hole in location previously marked. CAUTION: Drill through plastic only, do not drill through sheet metal brace behind plastic. See Figure 2 . FIGURE 2 3. Align slot in VCP mounting bracket with hole previously drilled. Loosely install (1) one #8 x 1 1/2" screw (item 1 pg 2) in dimple in metal brace behind plastic panel. See Figure 3. FIGURE 3 3 4. Remove and discard (4) four screws from the side of VCP. Partially install (4) four #8 x 3/4" screws (item 2 pg 2). See Figure 4. FIGURE 5 6. Carefully position housing top (item 4 pg 2) on VCP and slide VCP rearward until housing contacts plastic panel. Mark position of bracket and remove housing and VCP. Install (3) three #8 x 1 1/2" (item 2 pg 2) in holes in bracket and tighten (1) one screw previously installed. NOTE: Do not overtighten screws. See Figure 6. FIGURE 4 5. Align screws in VCP with slots in bracket and slide into position. Make sure wiring does not rub against edge of bracket. See Figure 5. FIGURE 6 4 FIGURE 7 8. Install housing bottom (item 5 pg 2) and secure to bracket by inserting clips into slots and pressing firmly. Make sure contour of housing matches floor of vehicle prior to securing clips. See Figure 8. 7. Make all necessary wiring connections to VCP. Check function of VCP and video system. See operating instructions included with components. For further assistance, refer to the video system manual for the technical support phone number listed for your area. Install VCP and tighten screws. Make sure VCP screws are positioned at bottom of slot. CAUTION: Do not overtighten screws. See Figure 7. ....., 5...