Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
Press the F.FWD button, EXIT 4. Precautions Precautions Troubleshooting Guide If you are having problems operating your product even though you have followed the instructions in this manual, check the following list of problems and corrective actions. You may be able to solve the problem yourself. Install Location For safety and optimum performance of your VCR: • Install the VCR in a horizontal and stable position. Do not place anything directly on top of the VCR. Do not place the VCR directly on top of the TV. • Shield it from direct sunlight and keep it away from sources of intense heat. Avoid dusty or humid places. Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes on the sides of the VCR. Avoid locations subject to strong vibration or strong magnetic fields. Important Copyright Information Unauthorized recording or use of television programming, video tape, film or other copyrighted material may violate applicable copyright laws. We assume no responsibility for the unauthorized duplication, use, or other acts which infringe upon the rights of copyright owners. A Note about Recycling This product's packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations. Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes. Avoid the Hazards of Electrical Shock and Fire • Do not handle the power cord with wet hands. • Do not pull on the power cord when disconnecting it from AC wall outlet. Grasp it by the plug. Note to the Cable TV System Installer This reminder is provided to call the Cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding – in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible. Moisture Condensation Warning Moisture condensation may occur inside the unit when it is moved from a cold place to a warm place, or after heating a cold room or under conditions of high humidity. Do not use the VCR at least for 2 hours until its inside is dry. FCC Warning This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR EVITER LES CHOC ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND. CAUTION: PROBLEM CORRECTIVE ACTION No power. • Make sure the power plug is connected to an AC outlet. • Make sure the power is turned on. Timer recording is impossible. • Make sure the timer recording is set correctly. • Make sure the power is off. • Make sure the VCR clock is set correctly. Cannot go into Recording mode. • Make sure the tape has a record tab. If needed, cover the hole with cellophane tape. Playback picture is partially noisy. • Adjust tracking control for a better picture by pressing the CHANNEL buttons. No playback picture (only sound can be heard.) • Head cleaning may be necessary. Refer to “Auto Head Cleaning” on page 8. • Make sure the VCR is not in the Menu mode. No or poor playback picture. • Turn on the TV and set the TV to channel 3. If channel 3 is already occupied for broadcasting, change the RF output to channel 4, and change the TV channel to channel 4. (See “RF Output Channel” on page 1 for the detail.) • Fine tune the channel reception on your TV. TV programs cannot be seen normally. • Re-check the ANT. IN and ANT. OUT connections. See page 1. • Press the VCR/TV button on the remote control so that the VCR/TV indicator on the VCR disappears. No VCR operation from the infrared Remote Control. • Make sure the power plug is connected to an AC outlet. • Check batteries in remote control. Video or color fades in and out when making a copy of a video tape. • You cannot copy a copyrighted video tape. You are experiencing copy guard protection. Specifications Video Heads : Four Heads Power requirement : 120V, 60Hz Operating temperature : 41°F~104°F Power consumption : 14 Watts (5°C~40°C) Dimensions : W 14-3/16” (360mm) Converter output : VHF Channel 3 or 4. H 3-5/8” (92mm) D 8-9/16” (216mm) Weight : 4.0 lbs. (1.8 Kg.) (approx.) • Designs and specifications are subject to change without notice and legal obligation. • If an explanation in the Owner’s Manual is not consistent across languages, please refer to the English version. - 4- EN 5. Playback 7. Other 6. Recor EN 44 To exit the menu - 5 - -MENU--MENU-TIMER PROGRAMMING AUTO REPEAT [OFF] B CHANNEL SET UP CLOCK SET LANGUAGE SELECT 33 To decid...