Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. 2. THIS PRODUCT MUST BE GROUNDED. UNITS WITH HEATERS ONLY: 3. Do not use this unit with any solid-state speed control device. 4. The combustion air flow needed for safe operation of fuel-burning equipment may be affected by this unit's operation. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. 5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. 6. Ducted fans must always be vented to the outdoors. UNITS WITH HEATERS ONLY: 7. Do not install this unit in a tub or shower enclosure. 8. Never place a switch where it can be reached from a tub or shower. 9. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. 10. Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally. CAUTION UNITS WITH HEATERS ONLY: 1. Provide a separate 15 AMP circuit. Use 14 GA. power cable of type which meets code. (Separate 20 AMP circuit and 12 GA. wire for Model 655, 655MX.) 2. This product is designed for ceiling installation only. This product is designed for installation in ceilings up to a12/12 pitch. Ductwork must point up. DO NOT MOUNT THIS PRODUCT IN A WALL. 3. Install in ceiling only, at least 6" from any wall. 4. For greatest efficiency, install heater so heat is directed toward tub or shower area. Avoid directing toward walls or windows. Models 657 & 657F ONLY: 5. Acceptable for use over a bathtub or shower when installed in a GFCI protected branch circuit. 6. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. 7. To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc., off power unit. 8. Please read specification label on product for further information and requirements. Advertencia PARA REDUCIR EL RIESGO DE INCENDIO, DESCARGA ELECTRICA O LESIONES PERSONALES, CUMPLA CON LOS SIGUIENTES PUNTOS: 1. El trabajo de instalacion y el cableado electrico deben de llevarse a cabo por personal competente de acuerdo con todos los codigos y las normas correspondientes, incluyendo los codigos y normas de construccion a prueba de incendios. 2. ESTE PRODUCTO DEBE SER CONECTADO A TIERRA. SOLAMENTE PARA UNIDADES CON CALENTADOR: 3. No utilice esta unidad con aparatos de estado solido de control de velocidad. 4. El flujo de aire para la combustion necesario para el funcionamiento seguro de equipo que quema combustible puede ser afectado por el funcionamiento de esta unidad. Siga las especificacio...
Эта инструкция также подходит к моделям:Вентиляторы - 659 (237.08 kb)