Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
These installations instructions will help you get the most out of your new KICKER sub. Thanks for buying KICKER. Enjoy! Installation Instructions VCVR Series vented enclosures combine KICKER’s CompVR subwoofer with computer designed and human-fine-tuned enclosures. They offer a level of bass performance never before thought possible from a commercially available enclosure. The VCVR Series enclosures are covered in carpet for protection and pre-loaded with a CompVR woofer. The location and orientation of your VC enclosure will affect the quality and quantity of the bass. Designed for use in SUVs and sedan type vehicles, the enclosure offers you several mounting options. The first rule you must remember is that the vent opening in these enclosures cannot be obstructed. Around the tuning frequency of the vent a substantial amount of bass is created. Therefore we recommend you leave at least four inches of clear space around the vent. If the enclosure is to be mounted all the way in the back of the vehicle, it works best to point the woofer toward the front of the vehicle. Conversely, if the enclosure is going to be mounted closer to the back seat, pointing the woofer toward the rear of the vehicle will give you the best results. These guidelines are good for when the enclosure is mounted cross-ways in the vehicle as shown below. Front Mounting, woofer faces the back of the car! AT LEAST 4" AT LEAST 4" FRONT Rear Mounting, woofer faces the front of the car! When it is more convenient to mount the enclosure along a side wall, your best option is to put it on the left side of the vehicle. (Shown below) This orientation will point the vent toward the rear of the vehicle and will produce the most low bass output. Remember to leave at least four inches of room between the enclosure and the back of the vehicle. A Least 4" Front Port Mounting After determining the best mounting position, check carefully in the areas where the mounting brackets will go. Make very sure that the mounting screws will not puncture the gas tank, brake lines, wire harnesses, etc., or interfere with any mechanical items on the underside of the chosen mounting surface. Turn the enclosure upside-down and attach the four mounting brackets to the bottom of the enclosure using the supplied smaller screws. Each bracket must be positioned so the rounded end protrudes approximately 3/4" from under the cabinet to allow a screw to easily pass through it for attachment to the vehicle.(See Diagram on opposite page.) Plug your subwoofer speaker wire into the terminals, using the red connector as positive and the black connector as negative. Hook the other end of this wire to your subwoofer amplifier in accordance with its owner's manual. With the enclosure right side up, securely attach it to the vehicle with the supplied larger screws. If the supplied hardware is not applicable to your installation, some other means of securely attaching the enclosure to the vehicle must be used. To avoid potential injury from forward movement of the enclosure during abrupt stops or accidents, this enclosure must be properly installed and securely fastened to your vehicle. (Mounting cont.) Model Woofer Imp. Power Top Bottom Height Width Handling* Depth Depth (Watts) (In., cm) (In., cm) (In., cm) (In., cm) VCVR10 C10VR 4 200 8-5/16, 21.1 11-1/4, 28.6 13-1/2, 34.3 30, 76.2 VCVR12 C12VR 4 300 10-3/4, 27.3 14, 35.6 15, 38.1 30, 76.2 NOTE: The use of a subsonic filter will significantly increase the power handling. The power handling specifications listed in the chart above include the use of a 24 db/ octave subsonic filter. A minimum of 12dB/ octave subsonic filter is recommended. Specifications 3 SPEAKER SYSTEMS LIMITED WARRANTY SPEAKER SYSTEMS LIMITED WARRANTY Kicker warrants this product to be free from defects in material and workmanship under normal use for a period of THREE (3) MONTHS from date of original purchase. When purchased from an Authorized KICKER Dealer it is warranted for ONE (1) YEAR from date of original purchase. If the product is labeled “B Stock” and purchased from an Authorized KICKER Dealer, it is warranted for THREE (3) MONTHS from date of purchase, regardless of place of installation. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction during the warranty period, Kicker will replace or repair (at its discretion) the defective merchandise with equivalent merchandise at no charge. Warranty replacements on “B-Stock” merchandise may have cosmetic scratches and blemishes. Discontinued products may be replaced with more current equivalent products. This warranty is valid only for the original purchaser and is not extended to owners of the product subsequent to the original purchaser. Any applicable implied warranties are limited in duration to a period of the express warranty as provided herein beginning with the date of the original purchase at retail, and no warranties, whether express or implied, s...